Structural Features
1 Its sealing surface adopt silicone rubber inflatable seal to guarantee zero leakage
2 The valve adopts double electromagnetic control and dedicated solenoid valve are used for control of both actions
Working Principle
When the valve is close , the dedicated solenoid valve for the pneumatic actuator will act ;the pneumatic actuator will drive the ball to rotate to the closing position through the valve stem , triggering the changeover push rod ;and then the gasket ring will be inflated to compress the ball surface to produce a seal .When the valve is open , the dedicated solenoid valve for the gasket ring will exhaust rapidly and disengage itself from the ball surface to a free state ; then the dedicated solenoid for the pneumatic actuator will act ,and the cylinder will drive the ball to rotate to open position
Main Material and parts
No | Name | Material: | Item | Name | Material |
1 | Body | WCB | 6 | Body | WCB |
2 | Stem | 1Cr13 | 7 | Spacer Ring | F6a |
3 | Ball | WCB+HCr | 8 | Swing Bar | Q235 |
4 | Stem | 1Cr13 | 9 | Yoke | Q235 |
5 | Sealing Seat | Fluorine Rubber | 10 | Pneumatic | Assembly |
Application Specification
Design &Manufacture | GB/T12224 |
Connection Enddimension | Structure | Manufacture’s Standard |
Flange Dimension | Manufacture’s Standard |
Test & Inspect | GB/T 9092 |
Material | Carbon Steel | GB /T 12229 |
Stainless steel | GB/T12230 |
Mark | GB/T 12220 |
Supply | GB/T 12252 |
Installation ,Use and Maintenance
1 Before installation , it is necessary to clean the valve and remove possible defects caused in the transportation process .
2. Check carefully whether marks and the name plate on the valve meet operating requirements
3 . Note the flow direct indicated on the valve body in installation .
4.This valve shall be fully open or fully closed in running and not be used as throttle valve
5.For long-term storge ,it shall be stored in a dry and ventilated room with periodic check to avoid rust
6, Knocking shall be avoid in the transportation process