[Maximum feed]: 20mm[Maximum output per unit]: 800T[Motor power]: 15000[Scope of application]: metal ore grinding[Applicable materials]: Metal ore
Product introduction
Wet ball mill for the horizontal cylindrical rotary device the external gear drive two positions lattice ball mill. Material by the feeding device by the material hollow shaft screw evenly into the mill first warehouse.The warehouse has ladder liners or corrugated liners built-in different specifications of the balls the cylinder rotation producing centrifugal force to carry the balls to a certain height then fall down hitting and grinding the material.Material in the first warehouse to reach rough grinding the throught the single compartment plate into the second warehouse the warehouse is set with a flat liner there are steel balls the material get further grinding.The powder is discharged through the discharge grate to complete the grinding operation. Ball mill consist of the feeding part discharging part rotation transmission (reducer small transmission gear motor electronic control) and other major components.Wet grinding materials mixed with water grinding grinding products is slurry.Wet grinding material is easy to flow the water will be timely washed away to prevent the phenomenon of crushing.In addition the water and surface active substances which dissolved in water penetrating the material microcracks contribute to the fine grinding of the material.Therefore the wet grinding capacity is higher than dry grinding the unit power consumption is low but the grinding ball loss is higher.
Structure principle
The ball mill motor drives the cylinder by the decelerating device. The crushed ore and the steel ball in the cylinder are affected by the friction force and the centrifugal force when the cylinder is rotated. After being brought to a certain height by the lining it is caused by the action of gravity the ore is gradually smashedunder the effect ofimpact and grinding .The pulverized ore is discharged from the tube through the discharge section.Discharged minerals in the spiral classifier to separate the qualified products then the coarse sand through the joint feeder and then back to the wet ball mill to continue grinding.The feeder is continuously fed evenly and the ore is continuously and uniformly fed into the wet ball mill via a combined feeder. The ground material is continuously
Technical advantage
1. Optimized configuration with high manganese liner
2. Use the special lubricating oil for the pad with wet ball mill
3. A wide range of processing materials higher production capacity than dry grinding low unit power consumption
4. Can be used multi-stage grinding process faster flow
5. Material operation can reduce the hollow shaft temperature protect the mill liner
Latest case
[Processing capacity]: 0.17~170t/h
[Scope of application]: This wet ball mill is often used to grind ore with finer fineness.
[Product Improvement]: The wet ball mill cylinder can use high wear-resistant rubber lining, which has good wear resistance, long service life and convenient maintenance.
Technical parameter
| Model | Speed (r/min) | Power (kw) | Inclination Angle (°) | Capacity (t/h) | Weight (kg) |
| Ф1800 | 3 | 19 | 5.5 | 45~50 | 2240 |
| Ф2200 | 8 | 14.25 | 7.5 | 35~55 | 3150 |
| Ф2500 | 10 | 11.81 | 11 | 35~55 | 4910 |
| Ф2800 | 16 | 11.14 | 11 | 35~55 | 5660 |
| Ф3200 | 17 | 11.18 | 15 | 35~55 | 6520 |
| Ф3600 | 33 | 12 | 18.5 | 45~55 | 7120 |
| Ф4200 | 33 | 7 | 30 | 45~55 | 9672 |