he thermal nozzle applied to the hot runner can realize segmented heating according to different heating density, spring coil spacing and radian. Mold heating ensures that the plastic melt has good fluidity in the mold cavity. Therefore, the mold temperature directly affects the molding, quality and performance of the products to be processed. Hot runner is a heating component used in injection mold to inject melted plastic particles into the mold cavity. The thermal nozzle is divided into open thermal nozzle and needle valve thermal nozzle. Because the form of hot nozzle directly determines the selection of hot runner system and mold manufacturing, the hot runner system is often divided into open hot runner system and needle valve hot runner system. Spring heating ring is generally used for heating

Main parameters:
Pipe: stainless steel
Insulating material: high purity magnesia powder,
Heating wire: ni8ocr20 nickel grid wire
Pipe diameter: Φ 5mm- Φ 25mm
Diameter tolerance: - 0.02mm-0.08mm
Pipe length: maximum length 3000mm
Pipe length tolerance: ± 5%
Appearance requirements: the surface shall be smooth without scratches, spots and depressions
Unheated length: customized on demand
Watt density: max. 40W / cm ²
Power tolerance: ± 10% (± 5% - 10%)
Surface temperature: tube surface temperature, maximum temperature 927 ℃
Element temperature: maximum heating temperature
Connector temperature: maximum temperature 260 ℃
Connection voltage: customized on demand
High voltage strength: minimum 800vac, maximum voltage of heating ring 1250v
Insulation resistance: ≥ 5m Ω (under 500VDC)
Leakage current: ≤ 0,5 MA (at 253 V AC)
Electrical performance: leakage current less than 0.5mA
Outgoing line mode:
Outgoing line
The inner outgoing line has better protection, and the wire is not easy to break, but the cost is higher than that of the outer outgoing line
Outlet angle:
Direct outgoing line, 90 degree angle outgoing line, side outgoing line, etc. are customized according to the needs of equipment installation and wiring