Model:Description:It is applied to the heating of the main splitter plate of the main hot runner, and can be shaped arbitrarily according to the application environment. The hot runner is generally composed of hot nozzle, main splitter plate, temperature control box and accessories. The first mock exam is the central part of the hot runner system of the diffuser plate. The splitter plate is a multi cavity or multi-point feed. It distributs the plastic melt transmitted from the main channel nozzles to the injection ......
It is applied to the heating of the main splitter plate of the main hot runner, and can be shaped arbitrarily according to the application environment. The hot runner is generally composed of hot nozzle, main splitter plate, temperature control box and accessories. The first mock exam is the central part of the hot runner system of the diffuser plate. The splitter plate is a multi cavity or multi-point feed. It distributs the plastic melt transmitted from the main channel nozzles to the injection nozzles of each injection point through the distributor. The splitter plate can make the mold cavity evenly filled, the plastic flow balanced and the system heat balanced. Shunt plate series include X-type, H-type, I-type, Y-type and K-type. There are two heating methods for the splitter plate. One is internal heating, that is, a heating rod is set in the flow channel to heat the plastic from the inside of the flow channel. The other is external heating. Generally, a heating hole is opened in the direction parallel to the flow channel, a heating rod is inserted or a heating ring is installed to heat the convection channel from the outside of the flow channel. Compared with the two methods, the internal heating method has higher thermal efficiency, but it is easy to cause local overheating in the hot runner system and increase the flow resistance of the melt; Although the external heating method will not produce local overheating, and the flow resistance in the flow channel is small, the flow channel is easy to process, the heating device is easy to purchase and easy to maintain.

Main parameters:
Pipe: stainless steel
Insulating material: high purity magnesia powder,
Heating wire: ni8ocr20 nickel grid wire
Pipe diameter: Φ 5mm- Φ 25mm
Diameter tolerance: - 0.02mm-0.08mm
Pipe length: maximum length 3000mm
Pipe length tolerance: ± 5%
Appearance requirements: the surface shall be smooth without scratches, spots and depressions
Unheated length: customized on demand
Watt density: max. 40W / cm ²
Power tolerance: ± 10% (± 5% - 10%)
Surface temperature: tube surface temperature, maximum temperature 927 ℃
Element temperature: maximum heating temperature
Connector temperature: maximum temperature 260 ℃
Connection voltage: customized on demand
High voltage strength: minimum 800vac, maximum voltage of heating ring 1250v
Insulation resistance: ≥ 5m Ω (under 500VDC)
Leakage current: ≤ 0,5 MA (at 253 V AC)
Electrical performance: leakage current less than 0.5mA
Outgoing line mode:
Outgoing line
The inner outgoing line has better protection, and the wire is not easy to break, but the cost is higher than that of the outer outgoing line
Outlet angle:
Direct outgoing line, 90 degree angle outgoing line, side outgoing line, etc. are customized according to the needs of equipment installation and wiring