The circulating electric heater heats the flowing medium by forced convection. It is composed of an immersion electric heater installed in a pressure vessel. During operation, the flowing medium is pumped into the heating chamber for heating. The heated medium flows out at the other end of the heater, which is a heating method of forced circulation through the pump. Small volume and large power. The circulating heater mainly adopts immersion heater, and the maximum power is 1MW. Fast heating speed, high temperature control precision and high thermal efficiency. Wide application range and strong adaptability: the circulating heater can be used in explosion-proof or ordinary occasions. Its explosion-proof grade can reach grade B and C, and its pressure resistance can reach 20MPa. Long service life and high reliability: the circulating heater is designed with corresponding power load for different purposes and adopts multiple protection, which greatly increases the safety and service life of the heater.

Main parameters:
Pipe: stainless steel
Insulating material: high purity magnesia powder,
Heating wire: ni8ocr20 nickel grid wire
Pipe diameter: Φ 5mm- Φ 25mm
Diameter tolerance: - 0.02mm-0.08mm
Pipe length: maximum length 3000mm
Pipe length tolerance: ± 5%
Appearance requirements: the surface shall be smooth without scratches, spots and depressions
Unheated length: customized on demand
Watt density: max. 40W / cm ²
Power tolerance: ± 10% (± 5% - 10%)
Surface temperature: tube surface temperature, maximum temperature 927 ℃
Element temperature: maximum heating temperature
Connector temperature: maximum temperature 260 ℃
Connection voltage: customized on demand
High voltage strength: minimum 800vac, maximum voltage of heating ring 1250v
Insulation resistance: ≥ 5m Ω (under 500VDC)
Leakage current: ≤ 0,5 MA (at 253 V AC)
Electrical performance: leakage current less than 0.5mA
Outgoing line mode:
Outgoing line
The inner outgoing line has better protection, and the wire is not easy to break, but the cost is higher than that of the outer outgoing line
Outlet angle:
Direct outgoing line, 90 degree angle outgoing line, side outgoing line, etc. are customized according to the needs of equipment installation and wiring