Welcome Customer !

Membership

Shangou Valve Co, Ltd.
Free Member ·1YRS
WenZhou,ZheJiang
Manufacturer

Main Products: valve,

Xwboo>Products

Shangou Valve Co, Ltd.Free·1YRS

  • E-mail

    59778276@qq.com

  • Phone

    0577-67975099

  • Address

    No. 430, Zhangbao North Road, Anfeng Industrial Zone, Oubei, Wenzhou, Zhejiang Province

Contact Now

VESeries pneumatic high performance eccentric ball valvePN16~PN64

Model
Nature of the Manufacturer
Manufacturer
Product Category
Ball Valve
Place of Origin
WenZhou City, ZheJiang Province
Overview
Ve series pneumatic high performance eccentric ball valve V-shaped ball core and seal ring adopts unique eccentric structure, which has the characteristics of compact structure, good sealing performance and long service life. It is widely used in chemical industry, electric power industry, textile industry, food industry, medicine industry, paper industry and so on.
Product Details
Product overview

Ve series pneumatic high performance eccentric ball valve V-shaped ball core and seal ring adopts unique eccentric structure, which has the characteristics of compact structure, good sealing performance and long service life. It is widely used in chemical industry, electric power industry, textile industry, food industry, medicine industry, paper industry and so on. The performance of this product is leading in China, reaching the international advanced level!

technical parameter

VETechnical parameters of series pneumatic high performance eccentric ball valve PN16 ~ pn64

Nominal diameter DN(mm)253240506580100125150200250300350400
Rated flow coefficientKv20305010015024037062094015402400390061509800
Nominal pressure PN(MPa)1.6、4.0、6.4
Flow characteristicsApproximately equal percentage
Inherent adjustable ratio100 (special requirements up to 200)!
Rated angle(℃)90
Equipped with actuatorPneumatic piston typeSingle acting modelSee table for details5~7
torque(Nm)
Double acting model
torque(Nm)
Electric actuatorCode name
torque(Nm)
Air source pressure(MPa)0.4~0.7
Electricity source220 v.ac or 380 v.ac
Input signal4~20mA、1~5(V.DC)Or above signal range control
Annex table
Pneumatic eccentric ball valveElectric eccentric ball valve
Code nameoptionCode nameoptionCode nameoptionCode name 
nothingWithout accessoriesSSolenoid valvenothingWithout accessoriesBPosition transmitter
PPneumatic valve positionerRAir filter pressure reducerDElectric operatorLLimit switch
EElectric / pneumatic valve positionerHhandwheelFServo amplifierKTorque switch
TElectric / pneumatic converterVRetaining valve handwheel  
BPosition transmitterQQuick exhaust valve    
LLimit switchXCurrent limiting speed regulating valve  
matters needing attention

1. Be careful in installation and construction, and do not hit the valve.
2. Before installation, the ball valve should be inspected to check the specification and model, and identify whether there is damage, especially for the valve stem. Also turn a few times to see if it is skewed, because during transportation, it is easy to bump the stem. Also remove the debris in the valve.
3. When lifting the ball valve, the rope should not be tied to the hand wheel or the valve stem to avoid damage to these parts, but should be tied to the valve body.
4. The pipeline connected to the ball valve must be cleaned. Compressed air can be used to blow away iron oxide chips, mud and sand, welding slag and other impurities. These debris, not only easy to scratch the sealing surface of the ball valve, in which large particles of debris (such as welding slag), but also block the small valve, so that its failure.
5. The position of valve handle rotation should be reserved during installation. 6. The ball valve cannot be used as throttling. 7. The ball valve with transmission mechanism shall be installed vertically.