The electronic control device that uses semiconductor electronic components to convert DC or low-frequency AC voltage into high-frequency AC voltage to drive low-pressure gas discharge lamps ( germicidal lamps ) , tungsten halogen lamps and other light sources. Electronic ballasts for fluorescent lamps are commonly used.
Electronic ballasts are divided into : electronic ballasts for fluorescent lamps, electronic ballasts for high-pressure sodium lamps, and electronic ballasts for metal halide lamps. Due to the use of modern soft-switching inverter technology, active power factor correction technology and electronic filtering measures, it has good electromagnetic compatibility and reduces the loss of the ballast.
Identify the quality of electronic ballasts
Remove the starter, disconnect the power supply, and test both ends of the ballast. If the ballast is of an older inductive type, only the inductive type can be used to test whether the coil is burnt out in this way. This old-fashioned ballast is broken, usually because the coil is blown, causing no voltage at both ends of the lamp, which will not cause the lamp to burn out. There are many situations for electronic ballasts.
The resistance values of the three ballasts can be measured separately according to the above-mentioned method to see if there is a big difference, so as to judge whether the ballast is damaged. You can also change the starter to see if the burning starter can't be disconnected and it's always on. In short, use the substitution method.
product advantages
(1) Energy saving . Electronic ballasts for fluorescent lamps, multi-use 20 is - 60kHz frequency of the supply tube, so that the lamp luminous efficiency than the frequency increase of about 10% ( by length of 4 feet lamp ) , and its low power consumption, so that the total light The input power is reduced by about 20% , which has excellent energy-saving effects.
(2) Eliminate stroboscopic light and make light emission more stable . It is helpful to improve the visual resolution and improve the efficiency ; reduce the visual fatigue of continuous operation and help protect the eyesight.
(3) The starting point is more reliable . After preheating the lamp, the starting point is successful at one time, avoiding multiple starting points.
(4) High power factor . Fluorescent lamps above 25W that meet national standards have a power factor higher than 0.95 . It should be noted, the national standard 25W high harmonic limits below a predetermined lamp, so that the power factor drops to 0.7 - 0.8 .
(5) Stable input power and output luminous flux : The product has good voltage stabilization performance. When the power supply and voltage deviation are large, it can still maintain the constant power of the light source and stabilize the illuminance, which is conducive to energy saving.
(6) Extend lamp life . The constant power of the product, the decrease of lamp current, and the reliable starting point can prolong the life of the lamp.
(7) Low noise . The noise of high-quality electronic ballast can reach below 35db , and people can't feel the noise.
(8) It can be dimmed . Properties required for dimming, such as: the original site of use or tungsten halogen incandescent dimming replaced with efficient fluorescent dimmable electronic ballasts, may be implemented in 2% - 99% of the wide range of dimming.
It should be noted that only well-designed electronic ballasts can take advantage of the above advantages. Although they are all electronic ballasts, the electronic ballasts used for metal halide lamps are much more complicated than those used for fluorescent lamps , or almost completely different. If the design or manufacturing process is not in place, a very small omission will cause failure.