Welcome Customer !

Membership

Shenzhen Ancend Electronic Technology Co.,Ltd.
Free Member ·1YRS
,
Other

Main Products: 安防监控设备

Xwboo>Products

Shenzhen Ancend Electronic Technology Co.,Ltd.Free·1YRS

  • E-mail

    1021568943@qq.com

  • Phone

    086-0755-83729961

  • Address

    Floor3,NO.26 Zhonghua Road,Zhonghua Industrial Area,Longhua Towm,Bao an District,Shenzhen City,China

Contact Now

Control Signal Lightning Protective Device

Model
Nature of the Manufacturer
Other
Product Category
Transmission Equipment
Place of Origin
City, Province
Overview
Control Signal Lightning Protective Device
Product Details
Introduction

Product Description


      AD-485 Control Signal Lightning Protective Device is wildly used to protect the transmission of data of signal equipment such as telemetry signal and remote control signal equipment in computer communication system, surveillance control system, access control intercom system, PLC automatic control system, fire alarm system from lighting and surge, so it can avoid the damages caused by lightning induced voltage, network voltage fluctuation interference and electrostatic discharge.
      Main features: AD-485 communicational signal surge protective series designed according to the standard of IEC surge protector. This product is standard screw fixing joint mode interface. It could protect 1-2 group circuit multiple rated voltage selection. It is easy to install and maintain. It adopts three-level tandem type, nominal discharge current series control signal lightning protective device can reach 5KA when sensitive communication special line was used. Response time is on the order of picosecond. It can protect the equipment adopting the newest semiconductor device.      
 
 
Product Parameters
 
 
Continuous operation voltage
5V
12V
24V
Class discharge current (8/20US)
5KA
5KA
5KA
Max discharge current (8/20US)
10KA
10KA
10KA
Limit voltage UP
15V
30V
45V
Date transmission rate VS
10mbps
10mbps
10mbps
Insertion loss AE
0.2db
0.2db
0.2db
Response time TA
1ns
1ns
1ns
Interface mode
Bayonet mode
Bayonet mode
Bayonet mode
Typical use
RS485 lightning protection
DC12V lightning protection
24V lightning protection
Protective mode
Line to line, line to ground
Failure mode
Communication circuit line-to-ground short circuit or off position
Product standard
54MM*25MM*25MM
Test standard
IEC61643-21:2000

Security system: telemetry circuit, remote control circuit, communication circuit.

Industry control system: telemetry circuit, remote control circuit, communication circuit.

Fire extinguisher system: telemetry circuit, remote control circuit, communication circuit.

Other control system: telemetry circuit, remote control circuit, communication circuit

 

Installation and Service

 

1.Control Signal Lightning Protective Device is in series between signal path and the equipment which is protected with connection of 1.2 to 2 mode.

2. Input end of Control Signal Lightning Protective Device should be connected to signal path and output should be connected to the equipment which is protected. Do not connect the wrong end.

3. Performance will be affect if PE line of Control Signal Lightning  Protective Device does not connect to equipotential bounding.

4. This product doesn’t need specific maintenance. Make sure that the device is near to the equipment, the closer the better. When the work system failure, please remove the device and check that if the system work well without the Control Signal Lightning Protective Device, if it work normally, it means that the device should be changed.   

Similar Product Recommend