| Matter | Causes | Troubleshooting |
| Oil leakage between back cover, stator and valves | rear cover stator bolt looseness (or uneven force), or O-rings damaged | Evenly tighten the bolt to the specified value, replace the seal (special) |
| Oil leakage at steering shaft | shaft seal ring excessive wear or damage | Replace the seal (dedicated) |
| feels light when turn the steering wheel slowly, feelsheavy when turn the steering wheel quickly | steering pump oil supply not enough | Check whether oil pump is working properly,(Including liquid level,pump efficiency, pipeline patency, etc.) |
| There is foam in the oil,irregular sound, the steeringwheel turns and the cylinder does not move | There is air in the steering system | Eliminating the air in the system, Check the suction pipe leaks or not, Orif the return nozzle is below the liquid level |
| Heavy steering continues to occur | Tank fluid is below the specified position | Add oil to prescribed height |
| Heavy oil viscosity | Use oil as required |
| Feel heavy when turn fast and slow, stressless | Check valve between P,T failure | Check the ball. lf the steel ball is missing, then insert the steel ball; lfthe ball gets stuck dirty,it should be cleaned; In both cases,it isnecessary to check the effectiveness of the sealing tape recovery. |
| Turns light when the load is light,turns heavier whenincreas the load | relief valve pressure lower than steering requirement | Adjust relief valve pressure to specified value (no more than 16MPa) |
| Relief valve stucked by dirt, Or spring failure,Or seal is damaged | Clean relief valve (required to check the effectiveness of seal taperecovery), or replace the spring or seal |
| steering wheel can't auto back to middle position | Spring broken or deformation | Replacement spring |
| Steering wheel rotate automatic swing to left or right | Rotor and linkage axes are not positioned correctly | Stop immediately! Align the teeth of the linkage shaft with rotor splines |
| No end point | Low pressure on relief valve | Appropriately increase relief valve pressure |
| Steering wheel rotates after turning to the end position | Low pressure on shock valves | Appropriately increase shock valves pressure |
| when machine is off, turn the wheel, cylinder not move | radial clearance or axial clearance is too large between radial and stator | Replace rotor and stator |
| Low viscosity of oil | Change oil |
| Vehicle deviation Or the cylinder is slow when turningthe steering wheel | shock valves failure (ball caught by dirty, or spring failure, or seal damage) | Clean shock valves,replace spring or seal |
| pressure of Steering system is able to adjust | Spring broken | Change spring |
| not good seals at safety valve make the valve always open | replace parts |
| Valve core stuck due to burr or oil stain | Remove, inspect, repair |
| Poor spool operation | Check if the spool is stuck by dirty |
| Spring bent or too soft | Change spring |
| Oil is not clean, valve plug orifice is blocked | Replace the cleaning fluid and unblock the orifice |