Welcome Customer !

Membership

ACE METER TECHNOLOGY CO.,LIMITED
Free Member ·1YRS
DaLian,LiaoNing
Manufacturer

Main Products: Flowmeter

Xwboo>Products

Throttling Orifice Flowmeter For Gas

Model
Nature of the Manufacturer
Manufacturer
Product Category
Throttling Flow Meter
Place of Origin
City, Province
Overview
Orifice flowmeter can measure the flow of gas, steam and liquid. It is a high range ratio differential pressure flow device composed of standard orifice and multi parameter differential pressure transmitter. It is widely used in the process control and measurement of petroleum, chemical industry, water supply and other fields.
Product Details

Throttling Orifice Flowmeter for Gas


Orifice flowmeter can measure the flow of gas, steam and liquid. It is a high range ratio differential pressure flow device composed of standard orifice and multi parameter differential pressure transmitter. It is widely used in the process control and measurement of petroleum, chemical industry, water supply and other fields.

Throttling Orifice Flowmeter for Gas_01

Throttling Orifice Flowmeter for Gas_02


Nominal diameterDN15-1800mm
Accuracy±0.5%R/1.0%
MediumGas, steam and various kinds of liquid
Temperature≤540℃
Pressure0.6mpa~40mpa
Range ratio15:1
ConnectionFlange
Body materialstainless steel
Power supply24VDC(must be equipped with differential pressure transmitter)
Output4~20mA;HART
Explosion proofExiaIICT4
ProtectionIP65 or IP68
EnvironmentEnvironment:-20~60℃


Adjustment of orifice flowmeter

1. Connect the signal line and power line

2. Open the inlet and outlet valves with the same opening

3. Open the stainless steel three valve group balance valve, slowly open the valve at the high and low pressure end of the orifice plate, and then close the stainless steel three valve group balance valve after the fluid passes through the flowmeter.

Installation conditions of orifice flowmeter [4]:

(1) The straight pipe section before and after the throttling piece must be straight without visible bending.

(2) The straight pipe section used for the installation of throttling parts shall be smooth. If it is not smooth, the flow coefficient shall be multiplied by the roughness to modify the sparsity.

(3) In order to ensure that the flow of the fluid in the first 1D of the throttling piece will form a fully developed turbulent velocity distribution, and this distribution will be made into a uniform axisymmetric shape

1) The straight pipe must be round, and the roundness of the 2D range before the throttling piece is very strict, and there is a certain roundness index. Specific measurement method:

(A) On the four vertical pipe sections of OD, D / 2, D and 2D in front of the throttling piece, measure the single measurement value of the inner diameter of at least four pipes respectively with the same angular distance, and take the average value D.  The difference between single measurement value and average value of any inner diameter shall not exceed ± 0.3%

(B) After the throttling piece, 8 inner diameter single measurement values are measured by the above methods at od and 2D positions, and the maximum deviation between any single measurement value and D shall not exceed ± 2%


Throttling Orifice Flowmeter for Gas_04

Throttling Orifice Flowmeter for Gas_05

Throttling Orifice Flowmeter for Gas_06

Throttling Orifice Flowmeter for Gas_07

Throttling Orifice Flowmeter for Gas

Similar Product Recommend