| n No Pulsating-Viscous Drag Through viscous drag, the fluid is pulled through the pump without impingement. The boundary layer attracts and drag successive layers of fluid molecules into layered flows of parallel streams. This is the simple principle of viscous drag and in the Disc pump it is a powerful dynamic force that “pulls “the fluid through the pump in a smooth laminar, Non-turbulent flow. n Less Wear-No pump Vibration Smooth flow through the pump saves wear and tear on the entire pump system. It also eliminates pump vibration and excessive noise. n Low NPSH Requirements Laminar flow means low NSPH. It prevents reduction in head and capacity and further reduces noise and vibration. The NPSH is about half to one-third of a centrifugal pump in the same service conditions. n Little maintenance required-The pump wears so slowly that spare parts and maintenance requirements are reduced dramatically, over 90% in many applications. n Few spare parts-The Disc pump comes with no recommended spare parts list, simply because it rarely needs them. n Little or No downtime-Regularly scheduled maintenance for normal bearing lubrication and seal flush is generally all that’s needed to keep the pump operating. n Solve the hard to pump problems-Protecting the Shear-sensitive and delicate solids. n Heavy Duty Shaft-Near zero Radial and Axial loads. There is less than 0.002-inch shaft deflection under the full-load, full-speed pumping. The bearing is a Disc pump will last in excess of 80,000hours with proper lubrication. |