Welcome Customer !

Membership

Jinan Zhibi Electronic Co., Ltd.
Free Member ·1YRS
JiNan,ShanDong
Manufacturer

Main Products: Servo Motor|DC Motor

Xwboo>Products
Product Categories

Jinan Zhibi Electronic Co., Ltd.Free·1YRS

  • E-mail

    zhibi@jnzbi.com

  • Phone

  • Address

    shizhong District,jinan city,shandong province

Contact Now

24v Brushed Dc Motor Controller 100w 200w PWM Dc Motor Controller

Model
Nature of the Manufacturer
Manufacturer
Product Category
Place of Origin
City, Province
Overview
This series of speed controller is a low voltage DC four-quadrant regeneration pulse width controller adopts special single-chip intelligent control system and has rapid response speed, steady operation, reliable work status and multiple protection functions.
Product Details

Small Size 24v Brushed Dc Motor Controller 100w 200w PWM Dc Motor Controller


 PWM pulse width modulation

Speed ratio:   
1:100
Control potentiometer: 
2W10K
 Input voltage:
20-55V VDC
 Output current:
 0-20A (amplitude limiting)
Input impedance: ≥50KΩ
Revolving speed (standard precision %)
1 %
Starting/braking time
1-20 S
Environment temperature

-10℃~+50℃

Environment humidity
≤80RH(no moisture condensation)(relative humidity)

 48v 25a dc motor controller dc motor speed controller 24v

DC2420BL1

1

尺寸


Problems

Causes

Recommended solutions

Motor is out-of-operation

1. Wiring is incorrect.

2. Command signal is0V.

3. Disconnection of INHIBIT enable terminal.

4. Current output is limited.

1. Carefully check the wiring between controller and motor

2. Regulate external potentiometer or external analog signal

3. Contact enable terminal

4. Regulate the output current of controller after confirming that motor is not blocked

Acceleration and deceleration time of motor is improper

Regulate of starting and breaking potentiometer is inappropriate

Regulate starting and breaking potentiometer

Motor vibrates after acting load

1. IR COMP setting is too big

2. Lack of current limit

1. Carefully regulate the setting of IR COMP

2. Regulate the TORQUE potentiometer after confirming that motor matches well with the driver

Speed up after acting load of motor

IR COMP setting is too small

Increase IR COMP setting

Slow down after acting load of motor

IR COMP setting is too big

Decrease IR COMP setting