High Quality Resin Casting Waterproof Cable Junction Box

Cast Resin Straight-through Joint

For polymeric cables and conductors

Universally suitable for connecting polymeric cables or conductorsinsulated with PVC, PE, XLPE and EPR (e.g. N(A)YY, NYM,TT). Suitable for compression or screw connectors on copper and aluminium condutors.

Characteristics

 Compact dimensions

 Splice area visible before casting

 High-quality transparent shockproof plastic shell

 Large filler aperture to facilitate casting

 Resistant to chemical agents

 Resistant to alkaline earth elements

 Stabilized against UV rays

 Longitudinally and transversely water-tight

 High electrical insulating values

 High mechanical strength

 Ready for immediate operation

 Quick and easy assembly saves time and reduces costs

Application/Suitability

 Indoor

 Outdoor

 Underground

 Water

 Installation ducts

 voltage level

 Uo/U (Um）0.6/1 (1.2) kv

Application/Suitability

1. Remove steps from end of mould. The opening must be slightly larger than the cable diameter( approx. 1 - 2 mm).

2. Insertion of cable sheath: φ ＜20mm: a=2 x c               φ ＞20mm: a=40 mm .

3.Install connectors.

4.Roughen, degrease and clean the cable sheaths.

5.Centre the splice: The distance between the connectors, and between the conductors themselves,as well as the splicing of each from the mould must be at least 5 mm.

6.Snap mould halves together.

7.Seal mould ends with PVC tape.

8.Mix the cast resin and fill in according to separate instructions up to 3 mm from upper edge of filler opening.

9.Insert cover.

10.Energizing of cables: Up to 1 kV immediately after casting.

Additional Instructions

Core insulation of PE, VPE, EPR etc.

 11. Roughen, degrease and clean cable insulation.

PILC cables

12. With armouring and jute: insert 20 mm of armouring into mould; do not insert any jute. With synthetic sheath: roughen, degrease and clean the cable sheath; insert for 20 mm into mould.

13. Insert lead sheath (a) as item 2. Roughen degrease and clean lead sheath and armouring thoroughly immediately before locking the mould halves.

14. Remove insulating material completely from conductor and belt insulation.

Fluid insulating material: Cover filler and paper insulation with Oilstop/ Adhesive agent.