The NT Dust SEAL ring is applied to hydraulically pneumatic piston rods to remove Dust from the external surface of the piston cylinder block and prevent sand, water and contaminants from entering the sealed cylinder block. The actual use of dust ring is mostly made of rubber material, its work...
Product Details
The NT Dust SEAL ring is applied to hydraulically pneumatic piston rods to remove Dust from the external surface of the piston cylinder block and prevent sand, water and contaminants from entering the sealed cylinder block.
The actual use of dust ring is mostly made of rubber material, its work is characterized by dry friction, so rubber material is required to have particularly good wear resistance and low compression permanent deformation performance. In recent years, also began to gradually promote the use of other materials and rubber materials and new dustproof seals, such as PTFE and O-ring combination, this sealing combination sealing effect is good. It has long service life and is widely used.
There are more and more products of NT Dust seal ring, which can be divided into many types according to its function, characteristics, structure type and sealing mechanism.
① According to the structure form: rectangular dust-proof sealing ring; Chamfering dust-proof sealing ring; Foot dustproof sealing ring; J type dustproof sealing ring; Triangle dust seal ring.
② According to the action: single action dustproof sealing ring; Double acting dust proof sealing ring.
⑧ according to have no skeleton points: no skeleton dust seal ring; Skeleton type dust seal ring.
④ According to whether the combination points: single type dustproof sealing ring; Combined dust-proof sealing ring.
Role of NT Dust Seal ring
An oil film is attached to the surface of the piston rod of the cylinder. The use of oil cylinder generally there is always dust or sand, dust, sand and so on and the surface of the piston rod oil film bond, will be brought into the cylinder, the piston rod lip seal ring lip scratch, or the piston rod surface scratch, will cause media leakage. Therefore, it is necessary to set a dustproof ring on the outside of the piston rod seal ring near the end face of the cylinder.
The NT Dust seal ring is installed in the groove. Because there is a certain amount of interference between the lip of the Dust ring and the piston rod, the lip of the Dust ring is close to the surface of the piston rod.
The piston rod for reciprocating movement, adhesion on the surface of the piston rod dust, sand, etc., is removed by the dust ring. There is a certain gap between the right part of the lip of the dustproof ring and the piston rod, which can reduce the friction resistance between the lip of the dustproof ring and the piston rod.