Front support ,Hopper , Spiral shaft, Filter net, Juice holding device, Back support , Out slag notch and so on .The mainly component is spiral .whatsapp/:+8613939575200:Jett@qualityfoodmachine.com
Product Details
whatsapp/:+8613939575200
:Jett@qualityfoodmachine.com
Introduction
1.This is a kind of spiral advancing extrusion.
2.There are whole stainless steel and inner stainless steel type. 3. It can make vegetable and fruit juice. 4.One outlet juice,one outlet fruit&vegetable pulp. 5.Processing material is vegetable&fruit which is crushed into not more than 2*2 cm size. 6.We can supply you with different Filter screens according to your needs on the hole diameter.
working principle1.Screw shaft is rotated in the clockwise direction along the dross outlet, bottom diameter is gradually increasing and the pitch is gradually reducing, when the material is into screw shaft, due to the spiral’s room gradually reduced, so as to form the material of the press.
2.Fruit and vegetable products into the hopper in advance with the pressing screw shaft, the juice is squeezed out through the filter into the bottom of the juice container, then the dross will be discharged by the gab between the screw shaft and Conical portion of the head regulator, the regulator can adjust the head gap size to adjust the resistance of dross, so can change the rate of dross, the size of regulator head should be required by the fruit and vegetable products process.
3.Changing the size of the gap, that is to adjust dross’s resistance, but if the gap is too small, under strong squeeze, some dross particles and juice will be squeezed together by the filter, although the juice increased, but the quality of juice will be reduced, the size of the gap should be user specific process requirements, so as to achieve the purpose of automatically separating dross and juice.