POOCCA PA-VZ series piston pump characteristics: Features: low noise, low noise operation in all pressure ranges in each series; high efficiency, due to small power loss; good reliability, high sensitivity, high stability, long life, Increase the reliability of the host.
Product Details
Axial variable Piston Pump VZ
POOCCA PA-VZ series piston pump characteristics: Features: low noise, low noise operation in all pressure ranges in each series; high efficiency, due to small power loss; good reliability, high sensitivity, high stability, long life, Increase the reliability of the host.
Name
POOCCA PA-VZ series Piston Pump
Series
Series VZ
Sizes
50 63 80 100 130
Nominal Pressure
250 bar
Maximum Pressure
280 bar
Operation Mode
Open Circuit
Model No.
Theoretical discharge rate cm3/rev
Maximum operating pressure MPa {kgf/cm2}
Permissible rotational speed min-1
Discharge rate adjustment range 1800min-1 L/min
Mass (Control method A) kg
VZ50
50.2
28 {280}
500 to 1800
0 to 90
40
VZ63
63
28 {280}
500 to 1800
0 to 113
47
VZ80
79.6
28 {280}
500 to 1800
0 to 143
55
VZ100
104.6
28 {280}
500 to 1800
0 to 188
75
VZ130
135.9
21 {210}
500 to 1800
0 to 244
105
PA-VZ type piston pump, with unique design of swash plate changing angle function. It is widely used in various places. Special design keeps low noise performance in the full pressure zone.
It is integrated by a variety of control methods to form a system and has the advantages of energy saving, miniaturization, and low cost functions.
The power loss is small, the oil temperature rise is reduced, and a smaller fuel tank is optional.
Widely used in machine tools, machine tools, forging, plastic forming machines, etc.
POOCCA PA-VZ series piston pump installation precautions
1. The installation position is optional. During trial operation, the pump body must be filled with hydraulic fluid and kept full during work. In order to reduce noise, all connecting pipes (oil inlet pipe, pressure oil pipe and shell drain pipe) need to be isolated from the oil tank with flexible components.
2. The oil pump bracket should be firm, rigid, and able to fully absorb vibration.
3. The concentricity of the pump and motor shafts is controlled within 0.100mm, and flexible couplings are used as much as possible to avoid bending moments and axial loads on the pump bearings.
4. The suction pipe diameter of the oil pump should not be less than the inlet diameter of the pump, and the flow through the oil suction filter should not be less than twice the flow of the oil pump. The finer the oil filter, the better the cleanliness of the working fluid, and the longer the life of the oil pump.
5. When the pump is installed higher than the oil tank, the height of the suction port from the oil level should be less than 1 meter (when using phosphate grease or water-containing hydraulic fluid, it should be less than 0.8 meters)
6. When the pump is installed, if it is higher than the liquid level of the oil tank, the suction center of the pump should be upward.
7. Note that the flanges, joints and the entire oil suction pipeline at the oil inlet must be strictly sealed to prevent air leakage, otherwise it will cause noise, system vibration, and cause a lot of foam in the fuel tank to reduce the pump's order.
8. The fuel tank should be equipped with partitions to separate the bubbles and dirt brought by the oil return. The oil return pipe should extend below the oil level (not directly connected to the pump inlet) to prevent air bubbles caused by splashing of the oil return.