，
MY series aluminum housing 1.5 hp single phase induction motor, with run capacitor, is made of selected quality materials and conform to the IEC standard. MY motors have features of good performance, low noise, little vibration and safety and reliable operation. The multiple of starting torque is 0.3-0.7 (MY), 0.45-0.75 (MYT). MY motors are suitable for the occasion where there requirements of starting torque is low and long-term continuous working, such as home electric appliances, pumps, fans, and recording meters, etc.
Product Detail
Motor Type: 1.5 hp single phase induction motor
Output Power: 0.06 kW - 3 kW
Frame Size: IEC 56 - 100
Number of Poles: 2 and 4
Voltage: 220V / 230V / 240V (can design based on customers` requirements)
Frequency: 50 or 60 Hz
Protection Level: IP54 or IP55
Insulation Class: B / F
Cooling Method: ICO141
Working Duty: Continuous (S1)
Product Parameter (Specification)
1.5 hp single phase induction motor
Type | Power (KW) | Rated Current (A) | Speed (r/min) | Eff (%) | Power Factor CosØ | Rated Torque Tn(N*m) | Tst/Tn | Tmax/Tn | Starting Current (A) | Run Capacitor (uf/V) |
3000rpm.2 poles | ||||||||||
MY802-2 | 1.1 | 6.52 | 2820 | 76 | 0.97 | 3.74 | 0.34 | 1.8 | 28 | 35 uf/450V |
1500rpm.4 poles | ||||||||||
MY90S-4 | 1.1 | 6.88 | 1410 | 72 | 0.97 | 7.46 | 0.34 | 1.9 | 30 | 40 uf/450V |
Production Features
Know More Us
Why Us
Service and Packing
Motor knowledge
What should I do if the insulation value of the motor is still low after repair?
Motor repair site
What should I do if the stator and rotor insulation of the generator is low after maintenance? Motor technicians have found that if the generator is slightly damp, the insulation value can be restored after a few hours of idling, and the insulation value should be greater than 50 megohms. When starting idling, pay attention to turn off the cooling water of the air cooler of the unit, and open a number of vents on the upper cover of the generator according to the situation. If the moisture is severe, you can use current drying or external heat source drying or send the generator set stator and rotor back to the factory. When drying in the kiln, the time must be appropriate and not too short. The stator and rotor that are too short and damp may not be completely dried. The cooling insulation value of the pending rotor will still be reduced. At the same time, the kiln temperature should be set appropriately, not too high or too temperature. High will damage the control system module of the generator. For large generator sets, when the rotor is still partially insulated, three-phase short-circuit drying is the simplest method.
