，-
E-mail
ivy@goanwin.com
-
Phone
+86-574-86562707
-
Address
No.318 Guangming Road, Guangming Industrial Zone, Zhenhai District, Ningbo, China
Product Categories
Ningbo Goanwin Machinery Manufacturing Co., Ltd.Free·1YRS
New High speed gripper feeder
NegotiableUpdate on November 22
- Model
- Nature of the Manufacturer
- Other
- Product Category
- Feeder and Accessories
- Place of Origin
- City, Province
Overview
New High speed gripper feeder
Product Details
·Mechanical driver device for material feeder.Applied with swing wheel transfer cam.Material feed degree on 165°.With 15° stop area in the end of cam design.Pre-pressure middle of cam and accompany device.It will make sure zero gap and high-precision material feed.
·Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
·Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
·Material feed length will be adjusted by the face side hand-roll.During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
·Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
·Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
| Feeder length | 0-80mm |
| Feeder width | 8-80mm |
| Max material thickness | 2.0mm |
| Material direction | Left→Right |
| Install location | Left |
| Drive axis round direction | CW/CCW |
| Feeder angle | 165° |
| Release gap | 0.5mm |
| Press gap | 0.1mm |
| Release angle | 60° |
| Press plate width | 50mm(Center max width 6mm) |
| AIr pressure | Min 0.44mpa |
·Mechanical driver device for material feeder.Applied with swing wheel transfer cam.Material feed degree on 165°.With 15° stop area in the end of cam design.Pre-pressure middle of cam and accompany device.It will make sure zero gap and high-precision material feed.
·Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
·Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
·Material feed length will be adjusted by the face side hand-roll.During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
·Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
·Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
| Feeder length | 0-80mm |
| Feeder width | 8-80mm |
| Max material thickness | 2.0mm |
| Material direction | Left→Right |
| Install location | Left |
| Drive axis round direction | CW/CCW |
| Feeder angle | 165° |
| Release gap | 0.5mm |
| Press gap | 0.1mm |
| Release angle | 60° |
| Press plate width | 50mm(Center max width 6mm) |
| AIr pressure | Min 0.44mpa |
Similar Product Recommend