Marine Globe valves and angle valves are found wide applications generally in flow regulation duties and also applicable to duties under high temperature pressure.
Marine Globe Valves
The globe valve got its name because of its spherical appearance and the fact that some valves of the past had hemispherical plates inside. However, the globe valves on the market today have round cut flat valve plates to hemispherical plate shapes that do not conform to the old traditional designs. The shape of the valve plate depends on the application, the manufacturer's design and the control required. Shut-off valves are widely used in industry and are very frequently used in the marine sector.
Key specifications/features
Short opening/closing time.
Only one sealing surface on the valve body and valve flap.
The valve is designed with a back seat seal construction.
Application:
SEWAGE TREATMENT, FIRE & BILGE & BALLAST, FRESH WATER, Sea Cooling Water, Oil Pollution, FIRE & BILGE & BALLAST, Tank Sounding, GRAY WATER
-JIS 5K /10K /16K/20K/ DIN PN6 /PN10/PN16/PN25/PN40 ANSI 150#/300#
Certificate: ISO9001, ABS, BV, DNV, LR
Related Standard:
Shipbuilding –valves and cocks-General inspection requirement JISF7400.
ISO5208-industrial valves-Pressure testing for valves.
Shipbuilding-Application for valves and cocks JISF7300.
They are very popular due to the following characteristics.
They have a long service life.
They control the flow of the fluid passing through (although not much, and for finer control it is necessary to use control valves with special valve profiles).
They can be held at any level from fully open to fully closed.
The valve lift required to achieve full flow is very small (unlike gate valves).
In angle valves it is possible to change the direction of fluid flow (unlike gate valves).
In globe valves, the fluid being controlled always flows under the valve seat to avoid pressure on the stuffing box and gland packing. Shut-off valves are used for specific applications where strict shut-off requirements exist. They usually use a metal-to-metal sealing surface, but sometimes soft seals such as PTFE or other composite materials that form the sealing boundary are used.
The different parts of a shut-off valve
Wheel nut: This is the nut on top of the wheel that helps to secure the wheel to the spindle or stem. It usually has a plain washer underneath.
Handwheel: This is used to open and close the valve. The larger the wheel, the less force is required to operate the valve, as the more torque is applied. This is the reason why wheel spanners are used on ships, because the longer the arm, the higher the torque.
Yoke nut: has a female thread and the stem or stem has a corresponding male thread. When the wheel handle turns the spindle, the stem rises or falls, thus opening or closing the valve.
Gland bolts: these are used to tighten the gland flange and gland bushings, thereby compressing the gland packing in turn and stopping leakage along the valve stem. On board, studs with nuts are usually used as they ar e easier to access and maintain.
Gland flanges and gland bushings: these are used to compress the gland packing and hold it in place. Sometimes they are combined together to form a single unit.
Gland packing: they are cut to the size of the stem and joined end to end, there should be no gap between the two ends otherwise fluid may leak. The packing is staggered so that the cut sections may not overlap each other and provide easy passage. A variety of packing materials can be used depending on the application such as PTFE, graphite tape etc.