Pedal flush valve

JX-0860

Customize/OEM

Water pressure;8（Mpa）

Flush time; 10 seconds

Outlet;15"

Size;15"

30*30*30（mm）

Brass raw materials.

Introduction: what is a pedal flush valve?

A pedal flush valve is a type of valve that is used to flush toilets. The pedal flush valve is located on the floor near the toilet and is operated by pressing down on the pedal with your foot. The pedal flush valve allows you to use less water when flushing the toilet, which can save you money on your water bill.

A pedal flush valve is a type of valve that is used to flush a toilet. It is operated by a pedal, which is usually located on the floor next to the toilet. The pedal flush valve allows the user to control the amount of water that is released into the bowl, which can save water.

Advantages of pedal flush valves

A pedal flush valve is a type of valve that is used to flush toilets. It is operated by a pedal that is located near the toilet. The pedal is pushed down, which opens the valve and allows water to flow into the bowl. The water then flushes the waste away.

How pedal flush valves work

A pedal flush valve is a type of valve that is used to flush a toilet. It is operated by a foot pedal, which can be found at the base of the toilet. The main advantage of using a pedal flush valve is that it allows for hands-free operation. This means that you don’t have to touch the handle in order to flush the toilet, which can help to reduce the spread of germs. In addition, pedal flush valves are often more durable than traditional handle-operatedflush valves, so they may last longer over time.

Different types of pedal flush valves

There are two main types of pedal flush valves: the Flushmate and the Geberit. The Flushmate is a pressure-assisted flushing system that uses a tank to store water under pressure. This type of valve is typically used in commercial restrooms because it provides a stronger flush than a gravity-fed system. The Geberit is a gravity-fed system that uses a chain to pull a plug from the bottom of the tank, allowing water to flow into the bowl and flush the toilet. This type of valve is typically used in residential bathrooms because it is less expensive than a pressure-assisted system. Bidet toilet bidets are a type of plumbing fixture that is typically used only by females. Bidets are considered to be an alternative to using toilet paper in cleansing the genital areas after urination or defecation.

How to install a pedal flush valve

Most valve stems are made of brass, which will corrode over time when exposed to water. To prevent this, it is best to apply a thin layer of petroleum jelly or plumber’s grease to the threads before screwing on the cap. If the valve head gets stuck in the open or closed position, you may use a small screwdriver to pry it loose. This will only work if the head of the valve is not already damaged.

To install a pedal flush valve, first, remove the old valve stem by unscrewing it counterclockwise. Next, clean the threads on the pipe with a wire brush and then apply a thin layer of petroleum jelly or plumber’s grease to them. Finally, screw on the new valve stem clockwise until it is tight. Pedal flush valves may also be installed using a flex or a threaded nut. Flexible tubing is attached to the end of the valve stem and then secured to the underside of a toilet rim with adhesive. The flexible tubing can be purchased at hardware stores in various lengths.