ACEPOM gear heater(gear fast heater) has temperature control, timing control function, digital display, sound prompt, error display, automatic display of heating time, automatic demagnetization. Mainly used for heating metal pieces of bearings, gears, couplings, railway locomotive wheel tyre, heart and other types, can be expanded to meet the needs of the assembly or disassembly.
Structure and working principle
1, the host is a special transformer short circuit heating structure, can be used directly to the yoke sleeve bearing wear or other heated workpiece. At work, the main power supply is turned on and the workpiece (equivalent to the secondary side winding) is induced to generate a short circuit current and is heated.
2, eddy heating is heated, the workpiece and the host's iron core to form a closed magnetic circuit, when work, the workpiece through the main line of magnetic field generated by eddy currents and heated rapidly.
Two 、 installation and debugging
1. The control box and the main engine are installed to the appropriate place. The main direction of the host should be horizontal and vertical, allowing the rear slope to be no more than 3 degrees.
2, after the installation is completed, before use, must check the electrical diagram, wiring is wrong.
3, correct, close the switch, switch on the power supply, at this time the voltmeter should have instructions.
4, the workpiece is heated to the host placed iron core middle yoke, gently move down, and make the workpiece. (if the workpiece thickness is constant, can be adjusted after the host lever bridge below the positioning screw, the yoke and the workpiece holding 2mm spacing, to facilitate continuous operation). At this point, the debugging is finished and can be put into use.
Three, operation procedures
1, the first heating, first set the temperature, the temperature sensor into the inner ring, press the start button, the workpiece is heated, to the temperature, the heater automatically shut down, and record heating to set the time required by the temperature.
2. Remove the workpiece so that it fits.
3 、 continuously heating the same specifications of the workpiece, the function selection switch to the control position, set heating time, when the workpiece is heated to the set time, automatically turn off the power supply.
4, after the completion of the work, put the power switch to the stop position, cut off the power supply.
Four, matters needing attention
Enclosure grounding must be good!
Press the starter button before the gear heater does not place the workpiece.
The control power of this series is AC380V, and the wiring of plug and plug should be corresponding.
Bearing heating temperature shall not exceed 120 degrees to prevent annealing; other parts of the maximum heating temperature rise is not greater than 300 degrees.
Five, custom requirements
Requirements for gears, or the size, weight, and heating time required for heating the workpiece.
We determine heating power according to your request and design heater structure.