ACEPOM322 dynamic data acquisition and analysis system is a Ethernet data acquisition product developed by our company.It can be connected with all kinds of desktop computers, laptops and industrial control computers to form a highperformance vibration data acquisition and measurement system.The product adopts high_precision 16_bit A/D conversion chip, which has the advantages of exquisite design, high measurement accuracy, fast transmission speed and convenient connection, etc. It is connected with ACEPOM322 software to form A powerful vibration acquisition, analysis and processing system, which is widely used in scientific experiments, industrial measurement and control fields.
Features:
Ethernet high-speed interface, plug and play;
High precision, low distortion, low noise;
Advanced delta sigma AD technology, 2 channels parallel acquisition, no time difference;
16-bit high precision AD, 100kS/s high speed parallel sampling per channel;
Strong data processing capacity, continuous and uninterrupted mass storage;
Input mode IEPE type vibration sensor;
Parameters:
1、AD resolution: 16bit
2、Accuracy : better than 0.5%(Full range)
3、Input:1-5 channels IEPE vibration sensor
4、Sample rate :100kS/s each channel
5、Voltage input range: ±10Vp
6、Frequency range :0.3Hz-30kHz
7、Power suppl:AC100∽240V
8、Input plug:BNC
9、size: 215mm(W)×80mm(H)×190mm (D)
10、weight:about 1kg
11、Software:ACEPOM322
Feature of software:
1、Ethernet interface is adopted to fully meet the real-time and fast requirements of signal testing and analysis, plug and play, convenient to use.
2、Sampling methods: oscillography, continuous recording, manual trigger, signal trigger, timing sampling, continuous signal trigger.
3、Sampling frequency: continuous collection of 100kS/s, file optional;
4、Sampling length: mass storage (depending on the size of the computer's hard disk);
5、Rich software support.
Sample:
The motor is a noise source of periodic vibration. When the motor is working normally, the graph which is close to the sine wave is measured by the accelerometer:
The large period is the motor rotation period, the fine burrs are the vibration of gears and other mechanisms.
When the motor is defective, there will be a large impact in each cycle, which is expressed as a peak in the time domain:
We use a relatively simple algorithm to identify fault motor on time domain: put a test cycle data is divided into several small segments, in each within a short period of valid value calculation, with the valid inference normal sine wave peak - peak, should be a valid value around 2.8 times, if a certain point over the threshold, think this is an illegal points, when a test cycle of illegal reach the threshold, I think this is a defective motor.
This algorithm has some limitations:
1、There will be different Numbers of illegal values at different sampling frequencies. We groped for a fixed sampling frequency to fix it. The sampling frequency should be 2 ~ 10 times higher than the maximum vibration frequency of the motor.
2、When the motor starts and stops, there will be abnormal impact, and these illegal points are also recorded. In the green part of the figure below, we can set a threshold to deduct the influence of this factor.
3、During the downtime, there will be very small clutter, as shown in the red mark in the figure below. We need to exclude these clutter, or these random signals will generate uncertain illegal points. We use the method of small signal cutting to screen these signals.
A complete collection process
Item No. | Standard configuration of single channel | Qty |
ACEPOM322 | Host | 1 |
ACEPOM322-ZDT | Vibration sensor(US PCB) | Optional |
ACEPOM322-ZDX | Cable of vibration sensor | Optional |
ACEPOM322-DYX | Power cable | 1 |
ACEPOM322-WX | Net cable | 1 |