Problem: Leakage
Reason 1:Check the leakage of parts of the seal is damaged, aging and so on
Solved 1 :Replacement of rubber parts
Reason 2:Check for defects such as trachoma, stomata or cracks in the cast parts of the leak
Solved 2:Replace defective castings
Reason 3:The fastening screws are uneven or not tightened
Solved 3:Uniform screw tightening
Problem: Metering is not accurate
Reason 1:Whether the skin wrist damage
Solved 1 :Replace the skin wrist (Note: before the replacement of the cylinder liner to clean the surface)
Reason 2:Dispense valve or distribution seat wear
Solved 2:Replace the dispensing valve or disassemble the valve seat
Reason 3:Check if the single bearing is damaged
Solved 3:Replace single bearing
Problem: The oil is not counting
Reason 1:Check if the flowmeter is reversed
Solved 1 :Replace the distribution valve assembly opening direction
Reason 2:Check whether the drive pins are broken
Solved 2:Replace the drive pin
Reason 3:Check whether the inner rotor assembly is frozen and frozen replace the drive pin
Solved 3: After the ice can be re-assembled