Start the engine
1, detection handle switch in the "ON" position;
2, Cold start, the choke handle hit the "OFF" position that is the top, if the ambient temperature is high or heat state, the choke handle hit "ON" position (that is, the normal use of the location);
3, to the carburetor pump oil until the return pipe to see the fuel outflow;
4, pull the starter to know the starter and start dial contact, and then pull to start the gasoline engine. Do not allow rough traction starter, discontinuous traction will cause spark plug ignition is not continuous, the machine can not start. Look at the machine is running normally, then put on the side of the normal running, continue to install other accessories, remember here not in the air does not flow or indoors.
All kinds of brush cutter blade Uses:
a. 2 teeth blade: for cutting low soft weeds, cutting diameter
b. 3 teeth blade: for cutting soft weeds, affordable
c. playing grass: apply to the lawn, soft ground on the small grass
d.40 tooth blades: for cutting hard weeds and shrubs (shrubs diameter 1.5-2.0 cm)
e.80 teeth blade: for cutting hard weeds and shrubs (balance, vibration, cutting more smooth)
Use
1. Mower mowing, you must first clear the miscellaneous areas within the mowing area, so as not to damage the grass to fight the head, blade. Start the engine cooler state, you should first close the damper, start and then timely open the throttle. If the turf area is too large. Mowing machine continuous working time is best not more than 4 hours.
2. Mower after use, should be fully cleaned, and check all the screws are tightened, the blade with or without defects, repair high-pressure hats, etc., but also according to the service life of the mower. Strengthen the vulnerability of accessories inspection or replacement.