Agitator Type Powder Mixer Product introduction V type mixer One end of the agitator type powder mixer machine is equipped with a motor and a reducer, the motor power is transmitted to the reducer through the belt, and the reducer is then transmitted to the V-shaped cylinder through the coupling. Make the V-shaped barrel...
Product Details
Description
Product introduction
V type mixer
One end of the agitator type powder mixer machine is equipped with a motor and a reducer, the motor power is transmitted to the reducer through the belt, and the reducer is then transmitted to the V-shaped cylinder through the coupling. Make the V-shaped barrel run continuously, and drive the material in the barrel to mix up, down, left and right in the barrel. V-type mixer series products are V-type asymmetric mixers, which are suitable for mixing powder or granular materials in chemical, food, medicine, feed, ceramics, metallurgy and other industries. The structure of the machine is reasonable and simple, the operation is airtight, and the feeding and discharging are convenient.
This agitator type powder mixer machine can use vacuum suction, work in a sealed state, no transmission mechanism inside, clean, hygienic and no dead ends, in line with GMP requirements. According to the material characteristics, the mixing device can be strengthened inside the cylinder to shorten the mixing time and improve the mixing uniformity of the material. The discharge valve adopts manual turbine butterfly valve, and the seal adopts anti-wear material without leakage.
Use and maintenance
1. Installation: Place the agitator type powder mixer machine smoothly, install the machine feet, and level it so that the machine can run freely.2. Before use, add oil to the place that needs to be refueled, and then perform no-load operation to check whether the fasteners are loose, whether the electrical is normal, and whether the machinery is running normally. If there is any abnormality, repair and debug it.3. Turn the feeding port to the top, open the feeding cover for feeding, the feeding amount should not exceed the specified volume, then close the feeding cover, and start the machine to run. If any abnormality is found on the way, it must be stopped for inspection.4. The inside and outside of the hopper must be rinsed clean after get off work or when changing varieties.