The function of feed pellet making machine is making pellet to feed animal poultry like cow,sheep,birds,rabbits,fish,shrimp,prawn and so on,the formula of the feed pellet will be provided with our machine for free.
Product Details
Introduction:
1.Feed pellet machine line include crusher machine,mixer machine,feed pellet making machine,dryer machine and packing machine.
2.We will suggest different kinds of crusher machine,mixer machine,pellet machine,dryer machine and packing machine according to different raw material and different application.
3.There have different models of our feed pellet machine,customers can choose as different requirement.
Technical information:
Model
Capacity
Main motor power
Feeding motor power
Conditioner motor power
Diameter of ring die
Diameter of final pellet
WSWH-25
1-2/h
7.5*2kw
0.75+0.55kw
2.2kw
250mm
3-8mm
WSWH35
3-5t/h
30*2kw
0.75+0.55kw
2.2kw
350mm
3-8mm
WSWH-42
4-10t/h
55*2kw
1.5+0.75kw
5.5kw
420mm
3-8mm
WSWH-520
5-12t/h
75*2kw
1.5+0.75kw
7.5kw
520mm
3-8mm
We often talk about preventing problems before they happen, so how to prevent particle machine failure early?
1. The pellet unit should be placed in a dry room and should not be used in places where corrosive gases such as acids are circulating in the atmosphere.
2.check the machine regularly to see if the work is normal. Check once a month. The contents of the inspection include the worm gear, the worm, the bolts on the lubrication block, the movable parts such as the bearings, and whether the rotation is flexible and wearable. The defects should be repaired in time. Continue to use.
3. After the pellet unit is used or stopped, the rotating drum should be taken out for cleaning and brushing the remaining powder in the bucket (only for certain pellet units), and then installed to prepare for the next use.
4. When the drum moves before and after the work, the M10 screw that has been adjusted before the bearing is adjusted to the appropriate position. If the gear shaft is turbulent, please adjust the M10 screw on the back of the bearing frame to the proper position, adjust the clearance so that the bearing does not make a sound, and turn the pulley. It is better to tighten it. If it is too tight or too loose, the machine may be damaged.
5. If the deactivation time is too long, the granule unit must be wiped clean and cleaned, and the smooth surface of the machine is coated with anti-rust oil, which is covered with a cloth.
As long as the above work is done, the particle machine failure can be greatly reduced, so that the efficiency of the pellet machine reaches the highest level.