I. Overview
The JM-B-35L vibration transmitter is an integrated vibration speed transmitter. It adopts a two-wire system and provides a 4-20mA current signal, which is proportional to the vibration speed of the bearing bush or bearing seat of the rotating machinery. It automatically collects vibration signals on the machine and uses the converted analog signals in PLC, DCS and DEH systems, etc.
2. Features
1. Mainly used to measure contact bearing vibration measurement of rotating machinery
2. Two-wire 4~20mA current output
3. All-stainless steel housing integrated design
4. The output has the ability to protect?
5. High anti-interference design
Three, technical parameters
signal
1. Measurement parameters: speed
2. Number of channels: single channel
3. Accuracy: ±1%FS@25℃
4. Sensitivity: 0.0 to 20.0 mm/s (default) ± 10%, Trms (true effective value)
[4mA is equal to 0.0 mm/s and 20mA is equal to 20.0 mm/s (default)]
5. Frequency response range: 10Hz-1KHz
6. Measuring range: 0-20.0mm/s (default), 0-50.0mm/s can be customized
Output
1.4~20mA: Large load 750Ω
physical
1. Diameter: 29.8mm
2. Height: 60 mm
3. Material: stainless steel
4. Output interface: MIL-C-5015, 2-pin (A, B end)
5. Protection: IP67
6. Weight: 100g
7. Connector wiring convention: Pin A: 4-20mA forward loop, Pin B: 4-20mA negative loop
surroundings
1. Working temperature: -40℃ ~+100℃
2. Storage temperature: -45℃~+110℃
3. Relative humidity: ≤99% non-condensing, non-immersion
powered by
1. Power supply voltage: 18~30 Vdc (typically 24Vdc)
Four, ordering guide
Order number | Measuring range A | Installation thread B | Cable selection C |
JM-B-35L- | 1: 10.0mm/s 2: 20.0mm/s* 3: 40.0mm/s 4: 50.0mm/s 5: 25.0mm/s 6: 30.0mm/s n: special requirements | 1: M10×1.0×10 (length) 2: M10×1.5×10 (length)* n: special requirements | 1: 2m armored 2: 5m armored 3: 10m armored 4: 2m non-armoured 5: 5m non-armoured * 6: 10m non-armoured n: special requirements |
Note: Specific requirements need to be described in the selection of special requirements, and "*" indicates the default option.