The QXB centrifugal diving aerator is a direct connection structure. The rotating impeller generates a centrifugal force in the water, and a negative pressure zone is formed around the impeller through the centrifugal force. Air is sucked in through the intake pipe. The sucked air and water are mixed in the mixing disc, and then this good and uniform mixture is automatically discharged from the exhaust. The outlet is discharged.
1. Brief introduction of QXB centrifugal diving aerator
The QXB centrifugal diving aerator is a direct connection structure. The rotating impeller generates a centrifugal force in the water, and a negative pressure zone is formed around the impeller through the centrifugal force. Air is sucked in through the intake pipe. The sucked air and water are mixed in the mixing disc, and then this good and uniform mixture is automatically discharged from the exhaust. The outlet is discharged.
This process includes the following aspects: the air and water in the mixing plate are mixed to produce a gas-liquid mixing effect, and the gas-liquid mixture discharged from the outlet forms circulation and convection. The high-speed movement of oxygen in a large number of air molecules obtains a very high oxygen absorption efficiency.
2. Technical parameters of QXB centrifugal diving aerator
3. Features of QXB centrifugal diving aerator
1. High oxygen dissolution rate, large proportion of small bubbles, high oxygenation efficiency and wide oxygenation area.
2. There is no dead zone in the pool, and the horizontal aeration air with air bubbles can completely wash every corner of the pool bottom.
3. Simple and compact structure, long service life of the unit, bearings that can withstand heavy loads, the shaft seal of the oil bath and the air sucked into the impeller cavity to prevent water from contacting the seal during operation, all of which ensure that the aerator can work continuously for 24 hours , Long-term trouble-free operation.
4. Save project investment, no need to provide air source, no need for blower, easy installation and low noise.
Fourth, the use of QXB centrifugal diving aerator
The QXB centrifugal submersible aerator is used in aeration tanks and aeration grit chambers of sewage treatment plants to aerate and mix the mixture of sewage and sludge, and to conduct biochemical treatment of sewage or aeration in aquaculture ponds.
V. Precautions for transportation and use of QXB centrifugal diving aerator
1. Never use the cable of the aerator to lift or suspend the aerator. When carrying or suspending the aerator, a chain with a hook can be hooked on the handle or on the lifting ring of the upper cover.
2. If the aerator is still in use or immersed in water, it can continue to be used when the temperature is below 0°C.
3. The submersible aerator is lubricated with grease or lubricating oil. Due to seal wear, grease or lubricating oil will leak out. At this time, please send the aerator to the maintenance department of our factory or commissioned maintenance point as soon as possible, and replace the seal to avoid burning out the motor.
4. When the power supply is not cut off, the aerator is not allowed to be moved, and people are not allowed to enter the water.
5. After the submersible aerator is installed, it should not be immersed in water for a long time. It is recommended to run it for at least 4 hours every half month to check its function and adaptability, or lift it up in a dry place for later use.
6. The submersible aerator cannot be placed at the sewage inlet. When the chassis is placed on mud or floating sand, the submersible aerator will sink due to vibration. In this case, it is recommended to suspend or place the aerator. On a larger base plate.
7. Due to the working principle of the diving aerator, the maximum immersion depth should not exceed 3 meters.
8. The submersible aerator must be grounded safely.