Welcome Customer !

Membership

HEFEI XINHU CANNED MOTOR PUMP CO.,LTD
Free Member ·1YRS
,
Other

Main Products: 泵

Xwboo>Products

GPA32-15H High efiiciency heating system circulator pump

Model
Nature of the Manufacturer
Other
Product Category
Heat pump circulator
Place of Origin
City, Province
Overview
GPA32-15H High efiiciency heating system circulator pump
Product Details

Scope of use

Air source heat pump combined supply system  

Product certification

The product meets the requirements of TUV、CE、EMC、RoHS、REACH、EEI≤0.23-part3 certification

Basic parameters

Rated voltage :220-240V AC Rated current :1.9AFrequency :50/60Hz
Maximum flow :7m³/h Maximum head :15m Maximum power :300 W
Rated flow :5 m 3/h Rated head :11 m Design pressure :1.0MPa
Noise :<48dB(A) EEI≤0.23-part3Protection class:IP44
Standby power :≤2W Insulation class :H Temperature class :TF95
Steering: clockwise when Viewed from the pump inletWeight :About 5kg(complete machine) Surge current :<10A


Media requirements

Medium: water or water + glycol (≤ 50%)mixtureMedium temperature : 2℃∼95℃
PH value of medium :6.5-8.5 Medium hardness :25°dH
Content of solid impurities in medium: diameter and length direction of solid impurities ≤ 0.1mm, and volume ratio ≤ 0.1%


Service environment requirements

The working environment temperature of the pump should be synchronized with the

medium temperature of 2~95℃, as shown in the figure on the right (the maximum ethylene

glycol concentration is 50%, that is, the mediumThe minimum temperature is -30℃)

Start and stop of pump

Starting time: the starting time of the water pump is less than 8S, the time

from power on to reaching the maximum speed

In PWM mode, when starting from the stop state of the water pump (without power

supply), 90% of the maximum speed must be reached in at least 8 seconds

In PWM mode, start from standby mode and reach 90% of the maximum speed in

at least 8 seconds

Shutdown time: the shutdown time of the water pump is less than 1 s, that is,

the time from power failure to shutdown of the water pump

Performance curve

Performance curve

This performance curve is suitable for normal temperature water, such as pump for

non-water medium, the hydraulic performance of the pump will be reduced , therefore ,

in the selection of pump, must consider the characteristics of the liquid medium

Installation dimension drawing

Installation dimension drawing

Product connection

12.1 Power connection

Voltage: 220-240V AC(±10% )

Frequency:50/60Hz

12.2 Signal connection(PWM)

PWM input signal voltage:4-24V

minimum input current:4mA

PWM input signal frequency: 100-2000Hz

PWM output signal: collector open-drain output, must be connected to a pull-up resistor,

the voltage is selected according to the signal acquisition range of

the host computer

Similar Product Recommend