FS Plastic corrosion resistant pump

Product Features:

FS plastic corrosion resistant pumps, motors and centrifugal professional plastic casing components. Has a beautiful appearance, simple structure, easy to use, wide range of features. Since the pump uses non-toxic ABS material, it applies to food, medicine, chemicals, machinery, textile, metallurgy, paper and other industries, transport the following 80 ℃, acid, alkali, salt solution without particles (not including strong acid (sulfuric acid concentrations greater than 60%; hydrochloric acid concentration greater than 30%), alkali, ammonia, glycerol, etc.) and organic solvents, such as detergents, detergents and the like.

Service Conditions:

1, the machine should be fixed on the concrete level of the feet or on the floor, water pipeline installation should prevent leakage outlet road to prevent leakage, all piping to support themselves, must not be supported by the pump in order to avoid damage to the pump.
2, suction pipe and discharge pipe into the pump must, consistent with the diameter, the lower end of the inlet check valve must be installed into the water depth of 50 cm or more should be maintained.
3, when you start, you should check the steering shaft is correct. If the power is turned on within 5 seconds, the motor can not turn off the power immediately, stop to check, otherwise it will burn out the motor windings, when there is no liquid in the pump body, not more than 30 seconds idling shaft, so as not to burn the seals.