Welcome Customer !

Membership

Shanghai Dafu Pump Industry CO.,LTD
Free Member ·1YRS
,
Other

Main Products: 泵

Xwboo>Products

FPZ Energy efficiency self-priming pump

Model
Nature of the Manufacturer
Other
Product Category
PLASTIC CORROSION RESISTANT PUMP
Place of Origin
City, Province
Overview
FPZ Energy efficiency self-priming pump
Product Details
Product Details

Product Features:

FPZ decay energy saving pump, using the CAS Shanghai Institute of Organic Fluorine material production of ethylene polyvinylidene fluoride (PVDF), reinforced polypropylene (RPP) a one-time injection molding. High mechanical strength, corrosion resistance strong. Media is not in contact with the metal, in order to extend the life of mechanical seal with pressure relief devices, without water cooling, high efficiency and low price, is an alternative to stainless steel, alloys and other non-metallic pumps fluorine ideal product.
Widely used: chemical, food and pharmaceutical, electroplating, paper making, environmental protection, water treatment and transport the vast majority of inorganic and organic acids, alkali, salt solution and its derivatives media. And can be in the range of -40 ℃ ~ 100 ℃ and reliable operation, 80FP-32 (100FP-32) type is the RP-54 (RPP-65) series water jet vacuum best supporting pump.


Service Conditions:

1, the machine should be fixed on the concrete level of the feet or on the floor, water pipeline installation should prevent leakage outlet road to prevent leakage, all piping to support themselves, must not be supported by the pump in order to avoid damage to the pump.
2, suction pipe and discharge pipe into the pump must, consistent with the diameter, the lower end of the inlet check valve must be installed into the water depth of 50 cm or more should be maintained.
3, when you start, you should check the steering shaft is correct. If the power is turned on within 5 seconds, the motor can not turn off the power immediately, stop to check, otherwise it will burn out the motor windings, when there is no liquid in the pump body, not more than 30 seconds idling shaft, so as not to burn the seals.



Similar Product Recommend