Welcome Customer !

Membership

NINGBO HELSH-TECH FLUID CO.,LTD
Free Member ·1YRS
,
Other

Main Products: 泵

Xwboo>Products

NINGBO HELSH-TECH FLUID CO.,LTDFree·1YRS

  • E-mail

    hls@helsh-tech.com

  • Phone

    0574-86906070

  • Address

    No.6,Sanqi Jingtou Industrial Point,Yuyao City,Ningbo City,Zhejiang Province

Contact Now

Working principle diagram of emulsion pump

Model
Nature of the Manufacturer
Other
Product Category
HEP1 homogeneous emulsion pump
Place of Origin
City, Province
Overview
Working principle diagram of emulsion pump
Product Details

Product introduction:

The pump cavity of hep1 homogeneous emulsion pump is equipped with a set of double stator and double rotor. The internal stress of rotor stator and cavity source materials can be eliminated by forging and other multiple processes, so as to improve the toughness and wear resistance of materials and prolong the service life. The rotor drive shaft adopts high-strength composite materials, and the parts contacting with materials are usually made of 304, 316L and other stainless steel. The sealing form is water-cooled double face mechanical seal. The pump is supported by the bearing box and supported by double bearing fulcrum to effectively control the shaft vibration. The coupling is connected with the motor. The working principle of the product is that the material is inhaled from the inlet of the pump, and the material is discharged from the outlet under the centrifugal force provided by the rotor after being homogenized and emulsified by the rotor.

Hep1 is suitable for the working condition which requires high speed of emulsification and not too strict effect of emulsification. It can meet the short distance transportation work. It is usually used with vertical high shear homogenizing emulsification machine to achieve better homogenizing emulsification effect.

HEP1均质乳化泵


1. There is a certain space in the cavity of the self-priming plastic magnetic pump, and the magnetic pump shall be equipped with "static bearing". Therefore, it can not be applied in the system software with working pressure, nor can positive pressure and negative pressure work. 2. Because the cooling and moistening of magnetic drive pump bearing lies in the medium transported, the empty transfer is relatively terminated. In addition, it can prevent full load operation when restarting after power failure in the middle of work. 3. If the conveying medium includes solid particles, a filter should be added at the inlet of the pump; If magnetic particles are included, a magnetic filter should be added. 4. In operation, the working temperature of the pump should be lower than 40 ℃, and the temperature rise of the motor should not exceed 75 ℃. 5. The medium and temperature delivered by the diesel rotor pump manufacturer shall be within the scope of the pump raw material approval. 6. If the conveying liquid is easy to accumulate and crystallize, it should be cleaned immediately after application to discharge the liquid accumulated in the pump. 7. For the long-term operation of stainless steel plate magnetic pump, the bearing and inner hole moving ring should be removed and inspected for damage, and the spare parts that should not be reused for many times should be removed and replaced. The idling of the stainless steel plate magnetic pump is a common operation error in the operation process, which will cause the magnetic pump to ignite. Because the internal and external magnetic rotors in the swing rotor pump will cause a lot of heat in the high-speed operation process, it must be cooled by liquid. If there is no liquid into the pump shell. The pump will be damaged due to long-term high temperature, so the stainless steel plate magnetic pump can not idle.

HEP1均质乳化泵

Similar Product Recommend