Welcome Customer !

Membership

XwbooElectronic ComponentsConnectorWiring Harness/Connecting Wire/Terminal WireCable Joint Waterproof Box/ Cable Splice Kits
  • $item.Title
  • $item.Title

Cable Joint Waterproof Box/ Cable Splice Kits

Haivo Electrical Co.,Ltd

Model
Nature of the Manufacturer
Manufacturer
Product Category
Wiring Harness/Connecting Wire/Terminal Wire
Place of Origin
ZheJiang, WenZhou

Cast Resin Straight-through Joint

For polymeric cables and conductors

Universally suitable for connecting polymeric cables or conductorsinsulated with PVC, PE, XLPE and EPR (e.g. N(A)YY, NYM,TT). Suitable for compression or screw connectors on copper and aluminium condutors.


Characteristics

 Compact dimensions

 Splice area visible before casting

 High-quality transparent shockproof plastic shell

 Large filler aperture to facilitate casting

 Resistant to chemical agents

 Resistant to alkaline earth elements

 Stabilized against UV rays

 Longitudinally and transversely water-tight

 High electrical insulating values

 High mechanical strength

 Ready for immediate operation

 Quick and easy assembly saves time and reduces costs


Application/Suitability

 Indoor

 Outdoor

 Underground

 Water

 Installation ducts

 voltage level

 Uo/U (Um)0.6/1 (1.2) kv



Application/Suitability

1. Remove steps from end of mould. The opening must be slightly larger than the cable diameter( approx. 1 - 2 mm).

2. Insertion of cable sheath: φ <20mm: a=2 x c               φ >20mm: a=40 mm .

3.Install connectors.

4.Roughen, degrease and clean the cable sheaths.

5.Centre the splice: The distance between the connectors, and between the conductors themselves,as well as the splicing of each from the mould must be at least 5 mm.

6.Snap mould halves together.

7.Seal mould ends with PVC tape.

8.Mix the cast resin and fill in according to separate instructions up to 3 mm from upper edge of filler opening.

9.Insert cover.

10.Energizing of cables: Up to 1 kV immediately after casting.


Additional Instructions

Core insulation of PE, VPE, EPR etc.

 11. Roughen, degrease and clean cable insulation.

PILC cables

12. With armouring and jute: insert 20 mm of armouring into mould; do not insert any jute. With synthetic sheath: roughen, degrease and clean the cable sheath; insert for 20 mm into mould.

13. Insert lead sheath (a) as item 2. Roughen degrease and clean lead sheath and armouring thoroughly immediately before locking the mould halves.

14. Remove insulating material completely from conductor and belt insulation.

Fluid insulating material: Cover filler and paper insulation with Oilstop/ Adhesive agent.


CLDIMmm^2MXY(mm)
MM106-195*2.5160*36
MM116-255*6190*48
MM1214-354*16240*50
MM1316-374*25270*65
MM1420-444*50360*80
MM1526-524*95430*95
MM1635-654*150530*120
MM1745-804*240700*180


  Haivo Electrical Co.,Ltd, is a provider of power equipment and services for the global electric utility industry. It mainly manufacture power transmission & distribution equipments FROM 10Kv to 220kv, covering many product series as Fuse cutout, Surge arrester, Composite & Porcelain insulator, Disconnector switch & Load Break Switch , Hardware fitting for overhead line, SEPARATABLE CONNECTORS and Cable joint & TERMINATION kits (cold & heat shrinkable cable accessories).
Similar Product Recommend