Membership
Help
Qingdao Yosion Intelligent Technology Co.,Ltd.
Qingdao Yosion Intelligent Technology Co.,Ltd.

TML-A Plate Tester
At present, there are three general methods for testing the transportable moisture limit (TML): 1 flow plate test, 2 penetration test, and 3 Portuguese/ Fan's test.
As each method has its own advantages, the test method should be determined by the local actual situation or by the competent authority.
TML-A Plate Tester is the equipment specialized for flow moisture point (FMP) and transportable moisture limit (TML) tests. It fully meets test requirements in IMSBC Code about ultimate fitness water for cargoes which may liquefy.

The flow plate tester is generally suitable for concentrate or other granular materials with a maximum particle size of 1 mm. It can also be used when the maximum particle size is 7 mm. It is not suitable for materials with particles larger than this limit, and the test results are not ideal for similar materials with high clay content.
The following tests are used for testing:
1. Moisture content of sample
2. Flow point (FMP) of test material under vibration force or periodic force of flow plate
3. The moisture limit of the test material.

● PLC control panel for easy operation.
● Premium quality of motor and screw drive pressing system offer precision and accuracy.
● Pressing position can be set according to operator's demand.
● Plate can spin 360°to provide maximum pressing surface.
● Pressing force is settable. Spring tamper return upward to original position after reaching maximum pressing position.
● Manual mode and automatic mode are switchable.
● Sound-light alarm for reminding next operation.
● Fault alarm system helps to eliminate faults.

1 Flow plate and accessories;
2 Tamping rod;
3 Graduated glass measuring cylinder and measuring tube with capacity of 100-200ml and 10ml respectively;
4 Hemispherical mixing vessel, rubber gloves and drying pan or pan with a diameter of about 30 cm;
5 There should be no air circulation drying furnace, and the temperature can be controlled at about 110C.
Temperature and humidity control
It is best to test in a room where the specimen is not affected by changes in temperature, air flow and humidity. The preparation of specimens and the various stages of the test process shall be completed at reasonable intervals to minimize moisture loss and in any case the test shall be completed on the same day. If possible, the sample container should be covered with plastic film or other cover.

Voltage | Power | Vibration mode | Vibration amplitude (mm) | RPM | Pressing Mode | Plate diameter (mm) | Vibration frequency |
220V/ | 40W | Mechanical | 12.5 | 1-50 | Manual | 254 | 50/ |

