-
E-mail
amy@safeinvert.com
- Phone
-
Address
#22 Liujiang Avenue, Liushi Town, Yueqing City, Zhejiang Province, China
Membership
Help
Zhejiang Saikong Electrical Technology Co., Ltd.Free·1YRS
amy@safeinvert.com
#22 Liujiang Avenue, Liushi Town, Yueqing City, Zhejiang Province, China
What is the difference between a transformer and an inverter
What is the difference between a transformer and an inverter? The inverter converts a DC power supply into an AC power supply, and a transformer is an electrical equipment that uses the principle of electromagnetic induction to achieve electrical energy conversion. It can convert a voltage and current AC electrical energy into Another voltage and current alternating current of the same frequency.
Simply put, an inverter is an electronic device that converts low-voltage (12 or 24 volt) direct current into 220 volt alternating current. Because we usually rectify 220 volt AC power into DC power to use, and the inverter has the opposite effect, hence the name. We are in a "" era, office, communication, leisure and entertainment. In a state, people not only need low-voltage DC power supplied by batteries or batteries, but also require 220 volt AC power that is indispensable in our daily environment. Inverters can meet our needs.
Transformer to inverter (1)
1. Required hardware: two 12V/2200UF capacitors, one 80W high-frequency transformer (12V to 300), two DC MOS tubes 3205, four AC MOS tubes 740, two PWM drive chips TL594, high-voltage capacitors 400V/ One 100UF, one LM324 (used for over-voltage control), and some transistors 8050 and 8550, which are used as drive circuits and a circuit board.
2. But it is still quite difficult, and the cost is less than 100 yuan.
3. A multimeter
4. A relay can switch between inverter and mains, but a control circuit is needed. The switching time is the reaction time of the relay, which is within 20MS.
5. For the uninterruptible power supply, it is generally controlled by thyristor, with fast response time and phase tracking, which is good for some demanding equipment. The control of charging the battery can be realized by the voltage sampling control circuit and adding a relay.
6. The principle is to drive the direct current through the chip and the control of the power tube, and then transform it to make the output 50hz alternating current.
Transformer to inverter (2)
The CU board calculates and sends out a sinusoidal PWM. The power PWM is modulated by the optical isolation of the H-bridge module and the MOSFET, and then directly input to the low-voltage side of the transformer. The DC source of the H-bridge is about 10V (don't dare to make it too high for fear of burning the transformer. ), the transformer outputs high voltage AC to supply power to the load. The load is an AC-to-DC adapter, which is converted to low voltage to supply a small board with LED. This adapter and the LED board are used as a load (in other words, I have not found such a low-power AC load with display).
To determine the correctness of the sine modulation, also look at the following figure: when the transformer is no-load, the output voltage waveform
After adding the load, the waveform becomes uglier and has been clipped (in order to have a high amplitude, the power supply voltage of the H-bridge is adjusted to about 11V), and the output peak value has reached 150V. Analysis of the reasons for the clipping may be the load Caused by the internal rectification link of the power supply.
It has been tested and verified that the routing transformer and H-bridge can output high-quality sinusoidal AC voltage under proper signal source modulation.