Welcome Customer !

Membership

Zhejiang Saikong Electrical Technology Co., Ltd.
Free Member ·1YRS
,
Other

Main Products: 变频器

Xwboo>Technical Article>What is the essential difference between industrial frequency and variable frequency motors? What is the point of control?

Zhejiang Saikong Electrical Technology Co., Ltd.Free·1YRS

  • E-mail

    amy@safeinvert.com

  • Phone

  • Address

    #22 Liujiang Avenue, Liushi Town, Yueqing City, Zhejiang Province, China

Contact Now
What is the essential difference between industrial frequency and variable frequency motors? What is the point of control?
Date: 2022/11/4Read: 36

What is the essential difference between industrial frequency and variable frequency motors? What is the point of control?

Aug 31, 2021

What is the essential difference between industrial frequency and variable frequency motors? What is the point of control?


1 The difference of power supply

The power frequency motor is powered by a power frequency power supply. Power frequency refers to the rated frequency used by power generation, transmission, transformation and distribution equipment, as well as industrial and civil electrical equipment. Our country uses 50Hz, and some countries use 60Hz. Our country's industrial three-phase power supply voltage is 380V, frequency 50Hz, and civil single-phase power supply voltage is 220V, frequency 50Hz. Therefore, the power frequency motors sold in China are designed according to the power frequency power parameters, while the motors sold to other countries and regions must be designed according to the local power parameters, such as: power supply voltage 400V, 420V, 440V, voltage frequency 60Hz, etc.


The frequency conversion motor is powered by the frequency converter. The power supply voltage and frequency input to the motor can be changed. When the motor starts and runs, it can be adjusted according to actual needs. The performance and quality of the inverter have a direct and obvious influence on the motor itself.

2 The difference of the motor cooling system

Power frequency motors generally use a self-fan cooling structure, that is, the wind pressure components of the motor rotate with the motor at the same time; and variable frequency motors generally need to be equipped with an independent fan for heat dissipation to ensure the compliance of the temperature rise performance of the motor under different speed conditions.


However, for variable frequency motors with small specifications and relatively small operating frequency ranges, self-fan cooling will also be used; for industrial frequency motors with small temperature rise design margins, independent fans can also be used; most of the high voltages with protection level IP44 and above Both the motor and the low-voltage high-power motor may use a cooling device with a booster system.

3 The difference between parts and materials

Under normal circumstances, the frequency conversion motor should use a special electromagnetic wire, at least the electromagnetic wire and insulating material with a higher insulation level should be used. The insulation level of the frequency conversion motor should be designed and manufactured in accordance with the principle of not lower than the F level.


For variable frequency motors with relatively bad operating conditions, or high-voltage and low-voltage high-power motors, the bearing system of the motor should take necessary protective measures to prevent shaft current from causing serious quality threats to the motor. Generally, the measures taken include bypass and insulation. Kind of measures.