HMP Series Multi-stage Water Pump

Application Field

• This series of pumps are used to pump clean water ,It can be used for domestic water supply, high-pressure system, auxiliary equipment, high-pressure and low-pressure pipeline water supply, garden irrigation system Garden, greenhouse and greenhouse, automatic water supply

• Small tanks using automatic control devices (control relays, pressure controllers).

• Equipment shall be installed at protected locations

• Not affected by atmosphere and moisture.

Pump Parts

• Pump body: cast iron

• Impeller: Brass/Stainless steel/P.P.O

• Motor shaft: Carbon steel/ Stainless steel

Motor

• Motor type: asynchronous, enclosed, air type Cooling system with built-in thermal protection

• Bearings: rolling (c&u)

• Stator winding: Copper/Aluminum

• Voltage: 110V-240V

• Frequency: 50Hz-60Hz

• Insulation class: B/F

• Protection grade: IP44/IP54

Service Conditions

• Maximum Ambient temperature: +40 ° C

• Maximum temperature of pumped liquid: +60 ° C

• Maximum pump chamber pressure: 8 bar

• Maximum suction height: up to 8M

• Only for clean water without abrasive (sand, clay, lime, etc.)

      Hydrogen index of water (PH): 6.5-8.5

1. Plug

2. Gasket

3. Nut

4. Pump cover

5. Nut

6. Partition

7. Diffuser

8. O-Ring

9. Impeller

10. Copper sleeve

11. Rolling mechanical Seal

12. Fixed mechanical Seal

13. Drop Guard

14. Front cover

15. Fiange gasket

16. Pipe Joint

17. Screw

18. Tie-rod

19. Bearing

20. Key

21. Rotor

22. Motor housing with stator

23. Wave-form washer

24. End cover

25. Tie-rod

26. Fan

27. Snap ring

28. Fan cover

29. Screw

30. Screw

31. Gasket

32. Terminal box base

33. Terminal box nut

34. Fairlead

35. Cable holder

36. Screw

37. Screw

38. Gasket

39. Terminal block

40. Screw

41. Capacitor

42. Terminal box cover

43. Screw

44. Screw

45. Support foot

Technicla Data

Overall and Mounting Dimension

Structure Diagram

Packaging Diagram