How to debug the electric valve actuator?Nov 24, 2020
As we all know, the electric valve is assembled and matched up and down by the electric head and the valve, and the valve is controlled by the electric actuator to realize the opening and closing of the valve. But it may not be just switched in place after installation. Therefore, the electric valve must be debugged before leaving the factory.
1. Wiring precautions
The valve electric actuator is allowed to be installed at any position, but it must be noted that the motor should be as horizontal as possible. The electrical box buttons correspond to each other. If they are inconsistent, press the stop button immediately to cut off the three-phase power supply and exchange any two phases of the three-phase power supply.
2. Adjustment of stroke control mechanism
● Turn the handwheel to "fully close" the valve, loosen the screw on the output shaft, and turn the closing cam clockwise to just press the closing micro switch and then tighten the screw.
● Turn the hand wheel to "fully open" the valve, loosen the screw on the output shaft, turn the opening cam counterclockwise to just press the opening micro switch, and then tighten the screw.
● Open and close the valve manually or electrically, and check whether the valve opening or closing meets the requirements. If it does not meet the requirements, fine-tune the above steps until it meets the requirements.
3. Adjustment of mechanical limit mechanism
The purpose of adjustment is to limit the valve's switch parts (disk plate, valve ball, etc.) within its working stroke (generally 90°) so that it cannot be rotated at will.
● Put the valve in the "fully closed" position, the position of the screw and the limit body is shown in the figure, screw the mechanical limit screw in the closed position until the top of the screw contacts the limit body, and then return the screw to 1- Tighten the lock nut after 2 turns.
● Keep the valve in the "fully open" position and adjust the mechanical limit screw in the open position according to the above method.
4.torque control mechanism adjustment
The torque control mechanism has been adjusted to the maximum output torque on the product nameplate before leaving the factory, and the user generally does not make adjustments.
The above is about the stroke control mechanism, mechanical limit mechanism, torque control mechanism and some wiring precautions of the electric valve electric actuator. After understanding these, I believe that many customers can also carry out the debugging by themselves to avoid affecting the delivery time and make it more portable and efficient.