Parameters of 3 Way Ball Angle Valve

JX-0418

Ball Angle Valve For Washing Machine

• Handle Type: Lever
• Handle Material: Polymer
• Thread Size: 3/4in
• Thread Standard: BSP
• Body Material: Brass
• Attachment Type: Compression, Threaded
• Maximum Working Pressure bar: 16 bar
• Safe for Use With Water
• Pipe Diameter: 15mm
• Threaded Connection: 3/4 in BSP
• Compression Fitting Size: 15mm
• Handle Colour: Blue
• Type : 3 Way
• Connection Size inch: 3/4in
• Connection Size mm : 20mm
• The production follow the valve standard strictly
• We test each piece valve during the production, quality control in forge, machine, assemble, and all the processes to guarantee the quality
• Jiaxin replaced the automatic engine with the eldest type of machine to make the products best

2 Hose connected, and it controls the water of both hot and cold water. A problem with the valve can cause the washer not to fill appropriately or not fill at all. You can do little to repair the valve itself, but you can clean the two inlet ports to restore full water flow. You can also test the valve to determine whether it has failed. Replacing a bad valve is a simple job and must be done with parts and procedures specific to your washing machine model.

You may be asking, “Why would I need to replace a brass wash machine valve?” Let’s take a look at why this is important. Older valves can leak and cause damage to your flooring. They also make it challenging to complete the laundry task because you have to keep turning off the water while moving from one sink or tub faucet to another. If that sounds like something, you want to avoid happening in your own home!

Replacing a brass wash machine valve is an easy task that can be completed in just minutes. All you need is a screwdriver and some pliers. Begin by shutting off the water supply to your home. Next, use the screwdriver to remove the old valve. You may need to use the pliers to loosen the connection. Once the old valve has been removed, replace it with the new one and reattach it using the screwdriver and pliers. Finally, turn on the water supply and check for leaks. If everything looks good, you’re done!

If you are uncomfortable completing this project yourself or going wrong after replacing the valve, don’t hesitate to a professional plumbing service for assistance. Happy plumbing!

If you are having trouble locating the valve or have any other questions, please don’t hesitate to contact us. We would be happy to help!

Replacing a brass wash machine valve is an easy task that can be completed in just minutes. All you need is a screwdriver and some pliers.

Shut off the water supply to your home. Next, use the screwdriver to remove the old valve. You may need to use the pliers to loosen the connection. Once the old valve has been removed, replace it with the new one and reattach it using the screwdriver and pliers. Finally, turn on the water supply and check for leaks. If everything looks good, you’re done! If something goes wrong after replacing or if you have trouble locating this device for any reason, please don’t hesitate to contact us as we would be happy to help! Happy plumbing!

If you have a brass valve leaking or needs to be replaced, then this blog post will show you how to do it. It’s not as difficult as it may seem and can help save you from costly repairs in the future. Follow these steps for replacing your brass wash machine valve:

1. Turn off the water supply at the shut-off valves 2. Disconnect the hose from the faucet by loosening the hose clamp with screwdriver 3. Remove old washer by unscrewing hex nut on top of stem 4. Install new washer onto the stem and tighten with hex nut 5. Reattach hose to faucet by tightening clamp 6. Turn the water back on at the shut-off valve.