In order to ensure safety, an ozone exhaust gas decomposition and destruction device is required to remove undissolved ozone gas and convert it into oxygen, which can be achieved by an ozone catalytic destruction device. The exhaust gas destroyer is generally placed on the top of the contact tank. If an oxidation tower is used for aeration, it can be placed on the ground.
After the ozone is in contact with water, the undissolved ozone gas is collected at the outlet of each ozone contacting chamber, and the ozone tail gas is drawn from the contact tank by a fan, and the water mist is removed by the tail gas dehumidifier and enters the ozone destruction device. The exhaust gas is preheated at the inlet of the destroyer to prevent it from condensing in the catalyst. The heating temperature is adjusted by the thermostat, and the safety switch of the thermostat can cut off the power when the temperature is too high. After entering the reaction chamber, the ozone molecules are decomposed as they pass through the catalyst. Subsequently, the exhaust gas is discharged from the catalytic bed by a centrifugal fan.
The heating - catalytic hybrid exhaust gas decomposer consists of the following components:
a. Catalytic reaction tank, including stainless steel catalytic tank, stainless steel mesh grid and support grid, catalyst, etc.; the control cabinet contains a set of display and adjustment instruments, and an alarm can be installed at the terminal for remote indication.
b. Heater, including: thermostat, stainless steel housing, heating element, etc.;
c. Centrifugal fan: centrifugal, aluminum turbine and blade, single/three-phase motor;
d. Control cabinet: The small control cabinet is generally integrated with the resolver.
main feature
a. Safety: The exhaust gas decomposer uses the current ideal catalyst, it does not consume ozone, does not absorb ozone, and it can completely ensure that the ozone will not reach dangerous concentrations.
b. Low temperature operation: The operating temperature is about 40℃, which can reduce the operating cost. Compared with the thermal decomposition type exhaust gas decomposition device, about 90% of the operating cost can be omitted.
c. Lower pressure drop: the pressure drop does not exceed 0.02MPa.
d. The outlet gas concentration is not higher than 0.1ppm and can be directly discharged to the atmosphere.