-
E-mail
amy@safeinvert.com
- Phone
-
Address
#22 Liujiang Avenue, Liushi Town, Yueqing City, Zhejiang Province, China
Membership
Help
Zhejiang Saikong Electrical Technology Co., Ltd.Free·1YRS
amy@safeinvert.com
#22 Liujiang Avenue, Liushi Town, Yueqing City, Zhejiang Province, China
What is the restart (reclosing) function after inverter fault tripping
The protection function of the inverter is very complete, and the operation speed of the single-chip microcomputer is also very fast, which can realize reliable protection. However, the improvement of the protection sensitivity will easily make the inverter subject to external interference, and there is a possibility of malfunction. Therefore, after the inverter trips due to a fault, it can automatically reclose one or more times to avoid unnecessary shutdowns. There are two main functions of this function: first, when the drag system trips due to malfunction, the reclosing function can quickly restore the startup to reduce the adverse consequences caused by the shutdown; the second is to prevent the trip caused by the non-repetitive electric shock of the power grid.
For such overvoltage, if the frequency converter trips, it can be reclosed.
The inverter can set the number of fault self-recovery (reclosing) and the interval time of fault self-recovery through the preset function parameters.
Overheating trip is one of the common faults of the inverter.
Overheating tripping is the first cause of heat:
1. Ambient temperature is too high: When the ambient temperature is too high, even if the output current of the inverter is not overloaded, the temperature of the inverter module may trip because it exceeds the allowable value.
2. Overheating during operation: Overheating during operation is further divided into: (1) Slight overload of the inverter: When the inverter is slightly overloaded, it will not cause an overcurrent trip, but if it takes a long time, if the heat dissipation is not very smooth, it may also cause an overheat trip. ; (2) High carrier frequency: the carrier frequency is high, the switching times of the IGBT are many, the switching loss is large, and the temperature of the module is easy to rise, even if the current does not exceed the rated current, it may cause the overheating of the inverter module; (3) IGBT Insufficient driving: If the driving voltage of the IGBT is insufficient, it is easy to cause the IGBT to overheat due to entering the amplifying state.
Secondly, there are also thermal reasons for overheating tripping:
1. Fan aspects: (1) Filter blockage: In a dusty workshop, the filter screen on the inverter fan is often blocked by dust and needs to be cleaned frequently. (2) Fan damage: The fan configured with the small-capacity inverter has a short service life and is easily damaged. When you hear a loud noise during operation, the fan should be replaced. (3) Fan circuit failure: It is common for the control circuit of the fan to fail. Therefore, when it is found that the fan does not rotate, it must be determined whether it is the problem of the fan itself or the problem of the control circuit.
2. In terms of heat dissipation plate: the rectifier module and inverter module are installed on the heat dissipation plate, and there are many heat dissipation slots on the back of the heat dissipation plate. The cooling slots can also easily become clogged with dust, causing the module to overheat.
3. Poor ventilation in the control cabinet: Most inverters are installed in the control cabinet, and the control cabinet also has the problem of whether the ventilation is good.