Welcome Customer !

Membership

Zhejiang Saikong Electrical Technology Co., Ltd.
Free Member ·1YRS
,
Other

Main Products: 变频器

Xwboo>Technical Article>How to connect the main shaft motor of the foam engraving machine to the inverter

Zhejiang Saikong Electrical Technology Co., Ltd.Free·1YRS

  • E-mail

    amy@safeinvert.com

  • Phone

  • Address

    #22 Liujiang Avenue, Liushi Town, Yueqing City, Zhejiang Province, China

Contact Now
How to connect the main shaft motor of the foam engraving machine to the inverter
Date: 2022/11/4Read: 34

How to connect the main shaft motor of the foam engraving machine to the inverter

Aug 19, 2021

How to connect the main shaft motor of the foam engraving machine to the inverter

Many people know the importance of the existence of the frequency converter to the foam engraving machine, but how many people can master the connection technology of the spindle motor and the frequency converter of the foam engraving machine? So, let us use this for a more in-depth and specific understanding and learning today!



In fact, it is not complicated to connect the main shaft motor of the foam engraving machine and the inverter. First of all, we must understand clearly the model of the relevant mechanical equipment, especially the number of cores of the frequency converter used and the number of interfaces of the motor spindle of the foam engraving machine.


Then, you can connect the relevant lines of the inverter according to the number of cores, and connect the three lines of the corresponding connectors with the UVW specifically corresponding to the inverter. In addition, if the motor spindle of the foam engraving machine is reversed, it is enough to exchange the positions of the two lines at will. At the same time, it is also necessary to pay special attention to the connection position of the ground wire must be carefully observed, otherwise abnormalities will occur during use.


Finally, after the second inspection of all the connected lines, the inverter can be connected to the power supply, which completely completes the wiring connection between the spindle motor of the foam engraving machine and the inverter. Although this series of working steps is not difficult and complicated, it also requires extra care and strict compliance with the corresponding operating specifications and requirements. This will not only ensure the normal installation and use of the foam engraving machine inverter, but also for the subsequent days. The operation and use effect of the foam engraving machine and its service life have a very important and critical effect, so remember not to ignore it.