Small two capacitor ML strong starting torque motor single phase is made of selected superior materials and conform to the IEC standard. ML motors have good performance, safety, reliable operation, nice appearance and can be maintained very easily, while with low noise, little vibration, and at the same time of light weight and simple construction. The compositive performance is good, the multiple of starting torque is 1.8 to 2.5. This series motor is suitable for the occasion where the requirements of big starting torque and high over load, such as air-compressors, s, fans, medical apparatus, and many other small machines.
Product Detail
Motor Type: Small two capacitor ML strong starting torque motor
Output Power: 0.12 kW - 4 kW
Frame Size: IEC 63 - 112
Number of Poles: 2 / 4
Voltage: 220V, 230V, 240V (can be customized according to users)
Frequency: 50 & 60 Hz
Protection Level: IP54 / IP55
Insulation Class: B/F
Cooling Method: IC411
Duty: S1 (continuous)
Use Conditions: Ambient temperature -15℃-40℃, altitude ≤1000 meters.
Product Parameter (Specification)
Small two capacitor ML strong starting torque motor
Production Features
Know More Us
Why Us
Service and Packing
FAQ
What are precautions when using the motor?
a. Pay attention to the assembly method of the motor bearing: Because the bearing is a high-precision product, it is easy to cause damage to the bearing channel if it is improperly assembled, resulting in damage to the bearing. When assembling the bearing, there should be a special mold, which can not be knocked at will. When pressing into the shaft, only a small circle can receive force, and when a large circle is pressed, only a large circle can receive force. Air pressure or pressure is required for assembly, and the upper and lower molds should be in a horizontal state during press-fitting. If there is an inclination, the bearing channel will be damaged due to force, and the bearing will produce abnormal noise.
b. Pay attention to the selection and control of the tolerances of the motor shaft and the bearing chamber: the bearing should be rotated flexibly without a sense of blocking after being pressed into the bearing. If there is obvious inflexible rotation, it indicates that the size of the shaft is too large and the tolerance needs to be lowered. If the bearing is pressed into the shaft and turned by hａnd and there is an obvious sense of "sand", it may be that the tolerance of the shaft is too large or the roundness of the shaft is not good. Therefore, when controlling the tolerance of the shaft and the bearing chamber, the roundness should also be controlled. At present, many domestic manufacturers only control the tolerance, but do not control the roundness.
