Welcome Customer !

Membership

Liyuan Motor Ltd
Free Member ·1YRS
,
Other

Main Products: 电机

Xwboo>Products

Liyuan Motor LtdFree·1YRS

  • E-mail

    sales@liyuan-motor.com

  • Phone

  • Address

    C-11-4 Tihu Mechanical&Electrical Industrial Zone, Chengyang Town, Fuan City, Ningde City, Fujian Province, China

Contact Now

Water Pump Use Induction Motor

Model
Nature of the Manufacturer
Other
Product Category
Asynchronous Motor
Place of Origin
City, Province
Overview
Y2 series iron housing three phase water pump use induction motor is a kind of TEFC squirrel cage motor with the national unified design.
Product Details

Product Introduction

Y2 series iron housing three phase water pump use induction motor is a kind of TEFC squirrel cage motor with the national unified design. It has the characteristics of high efficiency, energy saving, high starting torque, low noise, low vibration and easy maintenance. The grade of power and mounting measurements are subject to the IEC standard. This series motor is commonly used in the machinery without special requirement specially for reducer, air compressor, water pump, oil pump, packing and food machinery and so on.


Product Detail



Motor Type: Water pump use induction motor

Output Power: 0.18 kW - 315 kW

Frame Size: IEC 63 - 355

Number of Poles: 2, 4, 6, 8

Voltage: 220/380V, 380/660V others for request

Frequency: 50 & 60 Hz

Protection Level: IP54 / IP55

Energy Efficiency Rating: IE1 / IE2 / IE3

Insulation Class: B/F

Cooling Method: IC411

Duty: S1


Product Parameter (specification)



Water pump use induction motor

image001


Production Features



image002

image006

Know More Us


image006

Why Us



image008


Service and Packing


image009

FAQ



How to remove end cover of the motor?

1. In order to avoid mistakes during assembly, mark the joints between the casing and the end cover before disassembling the end cover.

2. Before disassembling the end cover of the sliding bearing, the grease (oil) should be discharged first, and the oil ring should be lifted and tied.

3. For the slip ring or commutator motor, the brush should be taken out or lifted, fastened, and the position of the brush holder should be marked. Pay attention not to damage the brush and lifting device when disassembling.

4. For motors with roller bearings installed on the load end, the non-load end should be disassembled first.

5. Generally, small motors only need to remove the end cover on the fan side, first remove the screws on the end cover, and then pull out the rotor, end cover, bearing cover and fan together.

6. For large and medium-sized motors, because the rotor is heavier, the end covers on both sides need to be removed. When removing the two-sided end cover, first loosen the upper cover screw, then loosen the lower cover screw, and then uncover the upper cover. After prying open, remove the upper tile, remove the oil ring, remove the lower tile, and remove the lower cover. To facilitate assembly, the load end and non-load end should be marked when disassembling.

7. When removing the rolling bearing end cover, the small cover should be removed first, then the screws of the large cover should be removed, and the large cover should be removed.

8. In order to prevent the stator and rotor from colliding and damage, after removing the end cover, an insulating cardboard should be placed in the air gap.

9. The dismantled small parts should be stored in a special parts box, and each group of parts should be assembled together as they are to facilitate the overall assembly