YD2 pole-changing multi speed ac motor is one of the main series products deriving from three-phase series. The motor can change rotational speed to meet the requirements of load state, so that they can properly match the demands of power and simplify adjustments speed system. They are widely used in such industrial and agricultural departments, as machine tools, mining metallurgy, spinning and weaving, printing and dyeing, chemical industry and agricultural machine. YD motor is equivalent to other foreign advanced machines, and therefore they are matching with single-machine or machine for export as well as motors for similar types imported from abroad.
Product Detail
Motor Type: YD2 pole-changing multi speed ac motor
Output Power: 0.44 kW - 82 kW
Frame Size: IEC 80 - 280
Voltage: 380V
Frequency: 50 or 60 Hz
Protection Level: IP54 or IP55
Insulation Class: B or F
Cooling Method: ICO141
Working Duty: Continuous (S1)
Product Parameter (specification)

Production Features




Know More Us


Why Us

Service and Packing

FAQ
The rotor of the motor suddenly stops rotating during operation, and then immediately smokes. What is the reason?
If you encounter a situation where the rotor of the hydraulic motor suddenly stops rotating during operation, and then immediately smokes, the power supply should be cut off immediately, and the reason should be analyzed first and then checked.
The rotor suddenly stops rotating during the normal operation of the hydraulic motor. The reasons are as follows:
①The load suddenly increases during the operation of the hydraulic motor
When the load of the hydraulic motor in operation suddenly exceeds about 2 times the rated load, or the load is suddenly blocked, the hydraulic motor will stop immediately; but as long as the overload or the stuck time is not too long, the hydraulic motor It will only increase the temperature and overheat, without causing subsequent smoke.
②Start other motors with higher power in the power grid
In the same power grid, when other high-power oil motors start, due to the large starting current, the line voltage will decrease, and other running motors will stop. However, when the high-power oil motor is started and the line voltage returns to the normal value, the stopped oil motor will start to run by itself. It can be seen from the failure phenomenon that this is not caused by the power supply voltage being too low.
③One-phase open circuit of the power supply line of the special motor for oil
The three-phase winding of the stator of the special motor for oil has two connection methods: △-shaped and Y-shaped. When one phase of the delta connection method is open, the winding insulation of one phase is completely scorched, and the other two phases of the winding insulation are burned out or can still remain intact; when one phase of the Y connection method is open, the two-phase winding insulation is burned. The insulation of the other phase winding is intact.
The above three reasons are relatively common in production. The LI YUAN motor summarizes them for reference only!
,




